Xiumei Jian

Dr. Xiumei Jian

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2018 in Environmental Technology & Innovation
Verified
Journal Article
Closed access
XJXiumei Jian
Xiumei Jian
XZXiuzheng Zhuang
Xiuzheng Zhuang
BLBosong Li
Bosong Li
XXXiwei Xu
Xiwei Xu
ZWZebin Wei
Zebin Wei
EJEnchen Jiang
Enchen Jiang

26 November 2020 in ACS Omega
Verified
Journal Article
Open access
XJXiumei Jian
Xiumei Jian
SLShan Li
Shan Li
YFYun Feng
Yun Feng
XCXueru Chen
Xueru Chen
RKRuibin Kuang
Ruibin Kuang
YSYan Sun
Yan Sun
Fe-modified biochars have been widely used in removal of Cr(VI) from water due to the resulting modified surface functional groups and magnetization property. However, few studies have synthetically investigated modification methods and synthesis parameters on the improvement of the removal efficiency of Cr(VI) by Fe-modified biochars. Herein, 10 types of corn straw-based magnetic biochars were produced using pre-modification and post-modification methods with various modifier ratios, and the highest heating temperature (HHT). Cr(VI) removal results suggest that the removal efficiency of pre-modified biochars ranged from 50.7 to 98.6%, which was much higher than that of post-modified (6.6–21.6%) and unmodified biochars (0.4–7.6%). The effect of synthesis methods on Cr(VI) adsorption was in the following order: Fe-modification method > modifier ratio > HHT. The adsorption kinetics and isotherm results of three types of pre-modified biochars were well fitted with the pseudo-second-order model (R2 > 0.99) and the Langmuir adsorption model (R2 > 0.99), respectively, indicating the surface homogeneity of the pre-modified biochars and unilayer chemisorptions of Cr(VI). Characterization results show that iron oxides or zerovalent iron particles were successfully deposited onto the surface of biochars and magnetism was introduced. A good Pearson correlation (r = −0.9694) between the removal efficiency and pH value in modified biochar suggests that the lower pH value may offer more positive charges and promote electrostatic attraction. Therefore, the dominant mechanism for enhanced Cr(VI) adsorption on pre-modified biochar was electrostatic attraction, resulting from its distinguished acidity nature. Our findings provide new insights into the high-efficiency removal of Cr(VI) onto Fe-modified magnetic biochars and will benefit future design of more efficient magnetic biochars.

30 December 2021 in ACS Omega
Verified
Journal Article
Open access
XCXueru Chen
Xueru Chen
RWRongtai Wu
Rongtai Wu
YSYan Sun
Yan Sun
XJXiumei Jian
Xiumei Jian
This study investigated the co-pyrolysis of blends of sewage sludge (SS) with rice husk (RH) and with hemp straw (HS) at different ratios by using thermogravimetry (TG) and its rate (DTG, derivative TG) analysis at heating rates of 10, 20, and 30 K/min. The resulting kinetic parameters of activation energy (Ea) were calculated by both Flynn–Wall–Ozawa and Kissinger–Akahira–Sunose models, followed by comparison of experimental values with calculated values to reveal the synergistic effects of SS/RH and SS/HS. With increasing additions of RH or HS to SS, a gradual decreasing trend in the experimental pyrolysis temperature range was evident, ranging from 144.5 to 95.2 °C for SS/RH and from 144.5 to 88.8 °C for SS/RH. Moreover, such temperature ranges were 6.7–20.4 °C less than the calculated values at the same blending ratio. The fitting results of the two kinetic models showed that with the same SS mass ratio, the experimental Ea* (average activation energy) of both SS/RH and SS/HS were less than the calculated Ea*. Especially, the experimental Ea* of 7SS–3RH was lower around 43.8% than the calculated Ea*, whereas the experimental Ea* of 3SS–7HS was lower by about 39.4% than the calculated Ea*. Synergistic analysis demonstrated that the co-pyrolysis of RH or HS with SS at various mass ratios presented obvious synergistic effects and then the decrease of Ea. The mechanism experiment showed that the co-pyrolysis of SS/HS may promote the decrease of Ea by changing the co-pyrolysis gas products or by increasing the overflow of volatile matter and then forming intermediate transition products, while SS/RH may accelerate the decrease of the Ea by using an appropriate K addition ratio from RH as a metal catalyst.

26 September 2023 in Sustainable Chemistry and Pharmacy
Verified
Journal Article
Closed access
ZHZiwan Hu
Ziwan Hu
RWRongtai Wu
Rongtai Wu
XPXiming Pang
Ximing Pang
CYChenghao Yu
Chenghao Yu
XJXiumei Jian
Xiumei Jian

18 September 2025 in Water
Verified
Journal Article
Open access
PDF file
Arif Reza, Ph.DArif Reza, Ph.D
Arif Reza, Ph.D
XJXiumei Jian
Xiumei Jian
FZFanjian Zeng
Fanjian Zeng
Xinwei MaoXinwei Mao
Xinwei Mao
Phosphorus (P) discharge from onsite wastewater treatment systems (OWTSs) poses a significant threat to water quality, contributing to eutrophication in nutrient-sensitive aquatic environments. In treated effluents, P predominantly exists as orthophosphate (PO43−), a highly bioavailable and reactive form that requires targeted removal. This study evaluates the performance of electrocoagulation (EC) as a polishing step for PO43− removal from OWTS effluents using 12 anode/cathode combinations comprising aluminum (Al), iron (Fe), magnesium (Mg), and stainless steel (SS). Key operational parameters, including treatment time, mixing speed, current density, pH, and initial PO43− concentration, were systematically investigated when synthetic denitrified effluent (20 mg P/L) was treated. Based on the performance, the four most effective electrode combinations (Al/Al, Al/Mg, Fe/Al, and Mg/Mg), along with a commercial benchmark (Fe/Fe), were further tested under extended hydraulic retention times (up to 48 h) in both synthetic and real (denitrified) wastewater. To date, none of the studies have systematically evaluated all possible anode/cathode combinations involving multiple electrode materials under uniform operational conditions. The Al/Al and Mg/Mg EC systems achieved rapid and high PO43− removal efficiencies (>95%), while Mg-based systems demonstrated sustained performance over prolonged treatment durations, especially in real wastewater. Bimetallic pairs such as Al/Mg and Fe/Al exhibited synergistic effects through enhanced coagulant generation and pH stabilization. The results indicated that PO43− removal efficiency was strongly influenced by electrode material selection, hydrodynamic conditions, and wastewater compositions, underscoring the need to design EC systems based on site-specific water quality conditions in OWTSs.