This paper presents a new technique of electrical energy generation using mechanically excited piezoelectric materials and a nonlinear process. This technique, called synchronized switch harvesting (SSH), is derived from the synchronized switch damping (SSD), which is a nonlinear technique previously developed to address the problem of vibration damping on mechanical structures. This technique results in a significant increase of the electromechanical conversion capability of piezoelectric materials. Comparatively with standard technique, the electrical harvested power may be increased above 900%. The performance of the nonlinear processing is demonstrated on structures excited at their resonance frequency as well as out of resonance.

This article presents a nonlinear approach to optimize the power flow of vibration-based piezoelectric energy-harvesting devices. This self-adaptive principle is based on a particular synchronization between extraction of the electric charge produced by the piezoelectric element and the system vibrations, which maximizes the mechanical to electrical energy conversion. An analytical expression of the optimal power flow is derived from a simple electromechanical model. An electronic circuit designed to perform the synchronous charge extraction is proposed. Theoretical predictions confirmed by experimental results show that the new principle increases the harvested power by 400% as compared with a quasilinear impedance adaptation optimization method.

Synchronized switch damping (SSD) principle and derived techniques have been developed to address the problem of structural damping. Compared with standard passive piezoelectric damping, these new semi-passive techniques offer the advantage of self-adaptation with environmental variations. Unlike active damping systems, their implementation does not require any sophisticated signal processing nor any bulky power amplifier. This paper presents an enhancement of the SSD technique on voltage source (SSDV) which is the most effective of the SSD techniques. The former SSDV technique uses a constant continuous voltage sources whereas the proposed enhancement uses an adaptive continuous voltage source which permits fitting the mechanical braking force resulting from the SSDV process to the vibration level. A theoretical analysis of the SSDV techniques is proposed. Experimental results for structural damping under single frequency and for vibration control of a smart board under white noise excitation are presented and confirm the interest of the enhanced SSDV compared to other SSD techniques. Depending on the excitation type, a 4- to 10-dB damping gain can be achieved.

This paper presents a new application of the ‘Synchronized Switch Harvesting on Inductor’ (SSHI). This nonlinear technique results in a significant increase of the electromechanical conversion capability of piezoelectric materials. Previous studies have shown the interest of this technique on steady state excited structures equipped with piezoelectric elements where the harvested power may be increased nearly tenfold compared to the standard technique. It is herein demonstrated that this technique is also very effective for pulsed excitation. It is shown that the SSHI technique increases the harvesting process efficiency between 250 and 450%, depending on the electromechanical coupling coefficient of the structure.