Powder metallurgy (PM) components are widely used in the auto industry due to the advantage of net-shape forming, low cost, and high efficiency. Still, usage of PM components is limited in the auto industry when encountering rigorous situations, like heavy load, due to lower strength, hardness, wear resistance, and other properties compared to wrought components due to the existence of massive pores in the PM components. In this study, through combining the powder metallurgy process and rolling process, the pores in the PM components were decreased and a homogenous densified layer was formed on the surface, which resulted in the enhancement of the strength, hardness, wear resistance, and other properties, which can expand its range of application. In this paper, we study the impact of different rolling feeds on the performance of the components’ surfaces. We found that with the increase of the rolling feed, the depth of the densified layer increased.
Novel Fe-based soft magnetic composites (SMCs) with hybrid phosphate-alumina layers were prepared by both sol–gel and ball-milling methods. The effects of the fabrication methods and the addition of Al2O3 particles on the microstructure and the soft magnetic performance of SMCs were studied. The formation of the hybrid phosphate-Al2O3 shell not only leads to the decrease of the total core loss, but also results in the reduction of the permeability and saturation magnetization. However, the degree of decrease caused by the different methods were not identical. The sample with 8% Al2O3 prepared by the sol–gel method showed the best magnetic performance, exhibiting a high-amplitude permeability (μa) of 85.14 and a low total core loss (Ps) of 202.3 W/kg at 50 mT and 100 kHz. The hysteresis loss factor and the eddy current loss factor were obtained by loss separation. The results showed that the samples with the same Al2O3 content prepared by different methods exhibited almost the same total core loss. However, the contribution of the hysteresis loss and the eddy current loss showed an obvious difference in behavior because of the change of the particle shapes and the refinement of the particle size during the ball-milling process.
In this investigation, the surface-rolling process was performed to improve the performance of PM (powder metallurgy) parts. Different rolling temperatures were applied and the effect of rolling temperature on the microstructure and mechanical properties of the surface dense layers in the samples were investigated. In the study, room temperature and temperatures of 100 °C, 200 °C, 300 °C were studied during the rolling process. The results confirmed that the sample prepared with a pre-heated temperature of 200 °C had the lowest porosity at the surface area. It also exhibited the highest surface hardness and wear resistance. The optimum rolling temperature was determined to be 200 °C and the related mechanism was discussed.
In recent years, the rolling densification process has become increasingly widely used to strengthen powder metallurgy parts. The original composition of the rolled powder metallurgy blank has a significant effect on the rolling densification technology. The present work investigated the effects of different carbon contents (0 wt. %, 0.2 wt. %, 0.45 wt. %, and 0.8 wt. %) on the rolling densification. The selection of the raw materials in the surface rolling densification process was analyzed based on the pore condition, structure, hardness, and friction performance of the materials. The results show that the 0.8 wt. % carbon content of the surface rolling material can effectively improve the properties of iron-based powder metallurgy parts. The samples with 0.8 wt. % carbon have the highest surface hardness (340 HV0.1) and the lowest surface friction coefficient (0.35). Even if the dense layer depth is 1.13 mm, which is thinner than other samples with low carbon content, it also meets the requirements for powder metallurgy parts such as gears used in the auto industry.