The advent of autonomous vehicles (AVs) has sparked many concerns about pedestrian safety, prompting manufacturers and researchers to integrate external Human–Machine Interfaces (eHMIs) into AVs as communication tools between vehicles and pedestrians. The evolving dynamics of vehicle–pedestrian interactions make eHMIs a compelling strategy for enhancing safety. This study aimed to examine the contribution of eHMIs to safety while exploring the impact of an incentive system on pedestrian risk behavior. Participants interacted with AVs equipped with eHMIs in an immersive environment featuring two distinct scenarios, each highlighting a sense of urgency to reach their destination. In the first scenario, participants behaved naturally without specific instructions, while in the second scenario, they were informed of an incentive aimed at motivating them to cross the road promptly. This innovative experimental approach explored whether motivated participants could maintain focus and accurately perceive genuine risk within virtual environments. The introduction of a reward system significantly increased road-crossings, particularly when the vehicle was approaching at higher speeds, indicating that incentives encouraged participants to take more risks while crossing. Additionally, eHMIs notably impacted pedestrian risk behavior, with participants more likely to cross when the vehicle signaled it would not stop.
19 November 2024 in Case Studies on Transport Policy
It is well known that road accidents tend to be more frequent in locations where a sudden change in road characteristics violates the driver's expectations. Most methods used to assess the design consistency are based on simplified speed profiles that give a coarse description of the vehicle dynamics along the road. This paper presents a new approach to quantify the road design consistency, based on continuous operating speed profiles. These profiles are based on the Gipps’ car-following equations, adapted to simulate the driver behaviour in the vicinity of horizontal curves under free-flow conditions. A methodology to calibrate and validate the Gipps’ behavioural parameters from field data is presented and applied to predict the speed profiles of three drivers for a set of rural road segments. The calibration is based on trajectory data collected with an instrumented vehicle and it follows an automated procedure that aims to minimize the differences between the predicted and observed speed profiles. The new consistency index is based on the deceleration distances and it allows to overcome some limitations of the existing methods.
1 January 2020 in Journal of Communication and Information Systems
This work proposes the use of a procedure for improving the loss of capacity assessment of heterogeneous bandwidth requests in the min slot-continuity capacity loss (MSCL) spectrum allocation algorithm. The particle swarm optimization (PSO) method is used to determine the best relationship between the number of requested slots and the amount of contiguous free slots in the requested and interfering paths. We also incorporate in the MSCL the influence of the number of hops of a route in its capacity evaluation. Considerable reductions in the path request blocking probability are achieved when the technique is applied, particularly when the number of hops is included to the evaluation.
As autonomous vehicles (AVs) become part of urban environments, pedestrian safety and interactions with these vehicles are critical to creating sustainable, walkable cities. Intuitive pedestrian-vehicle communication is essential not only for reducing crash risk but also for supporting policies that promote active mobility and efficient traffic flow. This study investigates pedestrian crossing behavior in a fully immersive virtual reality environment, building on previous work by the authors conducted in a CAVE-type simulator. Participants crossed between a conventional vehicle and an AV when they perceived it was safe. The analysis examines how external human–machine interfaces (eHMIs) influence crossing decisions, collisions, safety margins, and crossing initiation time (CIT) across different vehicle speeds and traffic gaps. Three hypotheses were tested regarding the effects of eHMIs on CIT, risk-taking behavior, and perceived safety. Results show that eHMIs significantly affect pedestrian decisions: participants delayed crossings when the eHMI indicated non-yielding behavior and initiated crossings earlier when yielding was signaled. Risk-taking behavior increased at higher vehicle speeds and shorter time gaps. Although perceived safety did not increase, behavioral results indicate reliance on visual cues. These findings underscore the importance of standardizing eHMIs to support pedestrian safety and sustainable urban mobility.