We developed a rigorous and exhaustive method for calculating the 0 K surface phase diagram of Bi/GaAs(001) by using density functional theory in conjunction with the cluster expansion formalism. In a search for ground-state alloy configurations of low energy surface structure prototypes, we found that the , , and structures possess only a few stable configurations, though each is stable over a wide range of chemical potential. In contrast, the and structures exhibit many stable configurations, suggesting their tendency towards configurational disorder at finite temperature. Monte Carlo simulations confirm a continuous disordering of the reconstruction with increasing temperature that comes to completion well below typical MBE growth conditions, in contrast to the structure, which remains ordered at high temperature. The calculated zero Kelvin phase diagram and finite temperature Monte Carlo results are in excellent agreement with STM in this work and experimental observations seen elsewhere. Furthermore, these results provide important insights into challenges posed by growth of GaAsBi alloys, namely Bi incorporation, CuPt ordering, and Bi clustering.
We fabricate site-controlled, ordered arrays of embedded Ga nanoparticles on Si, using a combination of substrate patterning and molecular-beam epitaxial growth. The fabrication process consists of two steps. Ga droplets are initially nucleated in an ordered array of inverted pyramidal pits, and then partially crystallized by exposure to an As flux, which promotes the formation of a GaAs shell that seals the Ga nanoparticle within two semiconductor layers. The nanoparticle formation process has been investigated through a combination of extensive chemical and structural characterization and theoretical kinetic Monte Carlo simulations.
Intermediate band solar cells (IBSCs) promise high efficiencies while maintaining a low device structural complexity. A high efficiency can be obtained by harvesting below-band-gap photons, thus increasing the current, while at the same time preserving a high voltage. Here, we provide experimental proof that below-band-gap photons can be used to produce nonzero electrical work in an IBSC without compromising the voltage. For this, we manufacture a quantum-dot IBSC. We use light biasing and make our cell operate at the maximum power point at 9 K. We measure the photocurrent response to absorption of photons with an energy of less than 1.15 eV while the cell is operating at 1.15 V. We also show that this result implies the existence of three quasi-Fermi levels linked to the three electronic bands in our device, as demanded by the IBSC theory to preserve the output voltage of the cell.
1 January 2021 in Journal of Engineering Education
Scanning tunneling microscopy of Sb-capped GaAs shows the coexistence of different surface reconstructions. The majority of the surface consists of an reconstruction typically observed for GaAs(001) surfaces. At step edges, an reconstruction, common for GaSb(001), is observed. We argue that strain couples the surface reconstruction to the film morphology. Density functional theory calculations show that the reconstruction is stabilized in GaSb films when the lattice parameter is constrained to that of GaAs, as happens in the middle of a terrace, while the reconstruction is stabilized when the lattice parameter is allowed to relax toward that of GaSb at step edges. This result confirms the importance of elastic relaxation in the coexistence of surface reconstructions.