Jinyoung Hwang

Prof. Jinyoung Hwang

orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 June 2019 in Nature Communications
Verified
Journal Article
Open access
PDF file
SPSung-Hoon Park
Sung-Hoon Park
JHJinyoung Hwang
Jinyoung Hwang
GPGyeong-Su Park
Gyeong-Su Park
JHJi-Hwan Ha
Ji-Hwan Ha
MZMinsu Zhang
Minsu Zhang
SLSang Hyun Lee
Sang Hyun Lee
Hybrid carbon nanotube composites with two different types of fillers have attracted considerable attention for various advantages. The incorporation of micro-scale secondary fillers creates an excluded volume that leads to the increase in the electrical conductivity. By contrast, nano-scale secondary fillers shows a conflicting behavior of the decreased electrical conductivity with micro-scale secondary fillers. Although several attempts have been made in theoretical modeling of secondary-filler composites, the knowledge about how the electrical conductivity depends on the dimension of secondary fillers was not fully understood. This work aims at comprehensive understanding of the size effect of secondary particulate fillers on the electrical conductivity, via the combination of Voronoi geometry induced from Swiss cheese models and the underlying percolation theory. This indicates a transition in the impact of the excluded volume, i.e., the adjustment of the electrical conductivity was measured in cooperation with loading of second fillers with different sizes.

2 October 2017 in Optics Express
Verified
Journal Article
Open access
PDF file
JHJinyoung Hwang
Jinyoung Hwang
JRJong Wook Roh
Jong Wook Roh
A novel, electrically tunable metasurface comprising a periodic array of disk-shaped silicon resonators is proposed. The dielectric resonators can be individually manipulated by applying external bias, inducing the complex permittivity modulation of indium tin oxide (ITO) embedded in the middle of the silicon nanodisks. Simulation data shows a reflectance shift from 61% to 8% at λ = 1111nm and a phase shift of 272.9° at λ = 1127nm with an applied voltage in the range of −4 ~4V. In addition, by simply adjusting the resonator geometry, any operating wavelength from 850nm to 1150nm can be achieved with the metasurface.

9 December 2020 in Physical Review Letters
Verified
Journal Article
Open access
PDF file
IRI. Ramiro
I. Ramiro
JVJ. Villa
J. Villa
JHJinyoung Hwang
Jinyoung Hwang
AMA. J. Martin
A. J. Martin
JMJoanna Mirecki Millunchick
Joanna Mirecki Millunchick
AMAntonio Martí
Antonio Martí
Intermediate band solar cells (IBSCs) promise high efficiencies while maintaining a low device structural complexity. A high efficiency can be obtained by harvesting below-band-gap photons, thus increasing the current, while at the same time preserving a high voltage. Here, we provide experimental proof that below-band-gap photons can be used to produce nonzero electrical work in an IBSC without compromising the voltage. For this, we manufacture a GaSb/GaAs quantum-dot IBSC. We use light biasing and make our cell operate at the maximum power point at 9 K. We measure the photocurrent response to absorption of photons with an energy of less than 1.15 eV while the cell is operating at 1.15 V. We also show that this result implies the existence of three quasi-Fermi levels linked to the three electronic bands in our device, as demanded by the IBSC theory to preserve the output voltage of the cell.

9 November 2018 in Scientific Reports
Verified
Journal Article
Open access
PDF file
JHJinyoung Hwang
Jinyoung Hwang
HSHiesang Sohn
Hiesang Sohn
SLSang Hyun Lee
Sang Hyun Lee
Quantitative models to predict the electrical performance of 1-D nanowire (NW) composite networks under external deformation such as bending and patterning are developed by Monte-Carlo based computations, and appropriate solutions are addressed to enhance the tolerance of the sheet resistance (Rs) of the NW networks under the deformation. In addition, several strategies are employed to improve further the robustness of the sheet resistance against the network deformation. In the case of bending, outstanding bending durability of a hybrid NW network coated on a 2-D sheet is confirmed with a numerical model, and a network of NWs aligned unidirectionally toward bend axis is introduced to alleviate the sheet resistance degradation. In the case of a narrowly patterned channel, the conductivity enhancement of a network of NWs aligned in parallel to the channel with reduced channel is validated, and a network made with two types of NWs with different lengths is suggested to enhance the tolerance of the electrical conductivity. The results offer useful design guidelines to the use of the 1-D NW percolation network for flexible transparent conducting electrodes.

8 May 2025 in Journal of Materials Chemistry C
Verified
Journal Article
Open access
SJSeung Taek Jo
Seung Taek Jo
JSJin Wook Shin
Jin Wook Shin
MKMin-Soo Kim
Min-Soo Kim
SPSang-Shik Park
Sang-Shik Park
WCWalter Commerell
Walter Commerell
JRJong-wook Roh
Jong-wook Roh
Ag micro-mesh electrodes were fabricated using self-generated cracks. By varying the crack structure, we observed a strong correlation between crack width and FoM, which peaked when the widths were predominantly distributed in the 1–2 μm range.

21 January 2025 in Physica B: Condensed Matter
Verified
Journal Article
Closed access
TVThanh Huong Vo
Thanh Huong Vo
SKSunjae Kim
Sunjae Kim
HRHeejoong Ryou
Heejoong Ryou
DJDae-Woo Jeon
Dae-Woo Jeon
JHJinyoung Hwang
Jinyoung Hwang
WHWan Sik Hwang
Wan Sik Hwang