Nickel oxide (NiOx) water oxidation catalysts with high catalytic activity have been electrodeposited from [Ni(en)3]Cl2 (en = 1,2-diaminoethane, NiOx-en) in a 0.10 M borate buffer (NaBi) solution (pH = 9.2). Electrolysis experiments at a fixed applied potential of 1.1 V (vs. Ag/AgCl) established that the NiOx-en films sustain a stable current of 1.8 mA cm−2 for extended periods, compared with 1.2 mA cm−2 for films derived from [Ni(OH2)6](NO3)2 and [Ni(NH3)6]Cl2 when tested in a 0.60 M NaBi buffer. XAS studies indicate that the γ-NiOOH phase is formed in each case whereas SEM studies revealed significant differences in film morphology. The NiOx-en films were found to be more homogenous and to have a higher electroactive surface area, as determined from capacitance measurements. The results highlight the influence that the choice of molecular precursor can have on the activity and robustness of electrodeposited NiOx water oxidation catalysts.
A versatile screen-printing method is applied for the preparation of efficient water oxidation catalysts based on a nanostructured β-MnO2 material prepared by a redox-precipitation method, and commercial β-MnO2. The catalyst films were tested for activity in water oxidation over a range of neutral to alkaline pH. The onset of water oxidation in case of the nanostructured MnO2 films is found at an overpotential (η) of 300 mV at pH 13.6 (1.0 M NaOH), with current densities reaching 10 mA cm−2 at η = 500 mV. The screen-printed MnO2 (nano) is one of the most active manganese oxide-based catalysts reported to date, despite consisting mostly of the common pyrolusite (β-MnO2) phase, so far generally found inactive in water oxidation. The films prepared from commercial β-MnO2 were found to be moderately active, with an onset of water oxidation at η = 500 mV (pH 13.6), and currents up to 5 mA cm−2 at η = 800 mV. At pH 6, the two samples exhibit similar activity and also match or surpass the performance of recent benchmark manganese oxides. X-ray absorption spectroscopy (XAS) studies suggest that the crystal phase is unchanged after prolonged electrochemical cycling. Scanning electron microscopy (SEM) analysis indicates very little corrosion of the surface morphology after prolonged catalyst operation at alkaline pH. However, high-resolution transmission electron microscopy (HRTEM) analysis shows the formation of a small amount of an amorphous phase on the surface of the nanorods after oxygen evolution over 12 hours in alkaline media.
We demonstrate that a focused beam of high-energy electrons can be used to map the vibrational modes of a material with a spatial resolution of the order of one nanometer. Our demonstration is performed on boron nitride, a polar dielectric which gives rise to both localized and delocalized electron-vibrational scattering, either of which can be selected in our off-axial experimental geometry. Our experimental results are well supported by our calculations, and should reconcile current controversy regarding the spatial resolution achievable in vibrational mapping with focused electron beams.