In this study, lithium was recovered from spent lithium-ion batteries through the crystallization of lithium carbonate. The influence of different process parameters on lithium carbonate precipitation was investigated. The results indicate that under the conditions of 90 °C and 400 rpm, a 2.0 mol/L sodium carbonate solution was added at a rate of 2.5 mL/min to a 2.5 mol/L lithium chloride solution, yielding lithium carbonate with a recovery rate of 85.72% and a purity of 98.19%. The stirring rate and LiCl solution concentration significantly impact the particle size of lithium carbonate aggregates. As the stirring rate increases from 200 to 800 rpm, the average particle size decreases from 168.694 μm to 115.702 μm. Conversely, an increase in the LiCl solution concentration reduces the lithium carbonate particle size, with an average particle size of only 97.535 μm being observed at a LiCl solution concentration of 2.5 mol/L. It was also observed that nickel and cobalt ions become incorporated into the crystal lattice of lithium carbonate, thereby affecting the growth and morphology of lithium carbonate.
In order to apply precipitated calcium carbonate (PCC) in the detergent industry, its ability to deposit calcium ions in hard water is an important process. In this work, the calcium ion deposition in the presence of PCC from different sources is investigated to reveal the influencing factors and mechanism of nucleation and crystal growth of CaCO3. SEM, XRD, Malvern particle size analysis, and calcium electrodes are used to evaluate the effects of PCC morphology, saturation of Ca2+, and PCC additive amount on the deposition behavior of CaCO3. Through SEM and Malvern particle size analysis, it is found that the precipitation of calcium ions is obviously accelerated by PCC acting as seeds. Moreover, calcium ions are effectively adsorbed on (211) crystal facets, thus prismatic and scalenohedral PCC crystals exhibit better adsorption performance than irregular cubic PCC ones. In addition, XRD demonstrates that PCC reduces or even eliminates the formation of crystals such as vaterite, displaying high deposition capacity under complex water conditions (slightly acidic or highly alkaline pH, low magnesium ion concentration (<0.01 M), and temperatures of 0–60 °C), forming thermodynamically stable calcite in water, which significantly controls the instability of the washing process.
The physical properties of sodium cocoyl glycinate (SCG) and the synergistic effects within the SCG/CAPB complex system were investigated using visible–ultraviolet spectrophotometry and a surface tension meter. Analysis of the synergistic parameters of the complex system revealed that the combination of SCG and cocamidopropyl betaine (CAPB) yielded superior results compared to the individual use of SCG. Building upon this, the ternary phase behavior of the SCG/CAPB/H2O system was further explored. Different lyotropic liquid crystal phases were identified using polarized optical microscopy (POM) and small-angle X-ray scattering (SAXS). Surfactant solutions with varying mass fractions exhibited diverse phase behaviors, including the micellar phase (L1), micelle–solid mixed phase (L1-S), hexagonal phase (H), and lamellar phase (Lα), with the insoluble solid phase predominating. The investigation of the ternary phase diagram of SCG/CAPB/H2O provided valuable guidance for detergent formulation screening, enriched the understanding of sodium cocoyl glycinate complex systems, and further promoted the utilization of amino acid-based surfactants in the field of personal care products.