A detailed numerical analysis of secondary flows in a transonic turbine is presented in this paper. The turbine stage is optimized by mitigating secondary flow through the method of non-axisymmetric endwall design. An automated optimization platform of NUMECA/Design3D was coupled with Euranus as a flow solver for the numerical investigation. The contoured endwalls of the stator and the rotor hub were designed based on equidistant Bézier curves along the camber line in the blade channel. The initial design samples were ten times the number of the design variables, and were generated through the LHS method for database generation. The optimization of the endwalls was achieved by using a state-of-the-art multi-objective optimization algorithm, NSGA-II, connected with the BPNN to increase the isentropic efficiency and decrease the secondary kinetic energy, while the mass flow and the degree of reaction were constrained to remain on the datum value as in the original geometry. The individual optimization of the hub endwalls of the stator and the rotor produced an increase in the efficiency of 0.27% and 0.25%, respectively, resulting in a cumulative improvement of 0.46% in the efficiency. The increase in the performance was analyzed at part-load conditions, and it was further confirmed through unsteady simulations.
The performance of a transonic high pressure turbine is mainly influenced by the unsteady interactions associated with the passing blades. In this paper, the unsteady flow interactions in a transonic turbine have been numerically investigated using the nonlinear harmonic (NLH) method in comparison with the steady and unsteady Reynolds-averaged Navier–Stokes (RANS). The comparison shows that the NLH method using three harmonics could capture the main unsteady flow interactions efficiently with about seven times smaller computational cost than the unsteady RANS, resulting in a more accurate time-averaged flow than for steady RANS. However, the continuity of the flow variables across the rotor-stator interface has shown some discrepancies compared with the unsteady RANS, which can be further satisfied by increasing the numbers of harmonics. The unsteady interactions are analyzed in detail; the results show that the wake and trailing edge shock from the upstream stator are the major sources of unsteadiness in the downstream rotor passage. The stator trailing edge shock impinges on the suction side of the passing rotor blades and generates pressure waves. These pressure waves are periodically reflected back to trigger the stator wake shedding. These waves are strong enough to travel through the rotor passage, and eventually affect the flow at the rotor’s trailing edge. The stator wakes are chopped by the downstream rotor, and travel through the rotor passage. This significantly enhances the unsteadiness of the flow near the rotor trailing edge. Lastly, the deterministic stresses and enthalpy distributions extracted from the NLH method have revealed that the effects of the unsteadiness are relatively weaker in the axial direction. Furthermore, the deterministic correlations analysis has shown that, some empirical deterministic correlations models based on the decay concept of compressors are not suitable for turbines.