The field of in-pipe robotics covers a vast and varied number of approaches to the inspection of pipelines with robots specialising in pipes ranging anywhere from 10 mm to 1200 mm in diameter. Many of these developed systems focus on overcoming in-pipe obstacles such as T-sections and elbows, as a result important aspects of exploration are treated as sub-systems, namely shape adaptability. One of the most prevalent methods of hybridised locomotion today is wall-pressing; generating traction using the encompassing pipe walls. A review of wall-pressing systems has been performed, covering the different approaches taken since their introduction. The advantages and disadvantages of these systems is discussed as well as their effectiveness in the inspection of networks with highly varying pipe diameters. When compared to unconventional in-pipe robotic techniques, traditional full-bore wall-pressing robots were found to be at a disadvantage.

SUMMARY: Tethered mobile robots are ideal for electrically noisy environments and for time-consuming tasks that require robust data communication and uninterrupted power delivery. However, tethers may become entangled in cluttered environments, leading to immobilisation and consequent mission failure. This work addresses real-time monitoring of tethers to detect tether entanglement, perform disentanglement through tether following and localise within line of sight. Experimental hardware is proposed to implement the tether monitoring techniques. Experiments are performed for single and dual mobile robots to search a target environment and entanglement detection is shown to be successful using quantitative metrics such as mean localization error.

The mechanical design of a robot often influences the choice of control strategy, especially for high-dimensional manipulator systems with multiple inputs and outputs. Striking a balance between hardware and software, it remains a significant challenge to design a control framework that is both easy to implement and high performing. This article addresses this concern by developing a systematic control architecture for trajectory tracking problems, focusing solely on position measurements. The approach involves constructing a dynamic model of the manipulator in the joint space through parameter identification techniques. A nonsmooth observer is then devised to estimate unmeasured states, unknown disturbances, and uncertain nonlinear functions in real time, which are incorporated into a nonsmooth feedback control design to provide a control solution. The stability of the system is ensured using the homogeneous system theory and Lyapunov theorems. To validate the effectiveness and feasibility of the proposed tracking control approach, extensive evaluations are conducted on a six-degree-of-freedom manipulator, including tests for tracking performance and repeatability.

This paper studies the viability of using a class of phase-changing materials for the design of controlled variable stiffness robotic joints which enable the design of robots that can operate in confined spaces. In such environments, robots need to be able to navigate in proximity or while in contact with their environment to reach one or more manipulated target. Joints with controllable stiffness can substantially enhance functionality of this class of robots where relatively higher joint stiffness is required to support the robot weight against gravity and low stiffness is desired when operating in complex or delicate environments. The research work presented in this paper focuses on examining thermorheological fluids (TRF) to design and manufacture thermally controlled variable stiffness joints. Two phase-changing materials are considered in the study: low-melting-point solder and hot-melt adhesive. Both materials are embedded in a custom designed joint fabricated using 3D printing and silicone casting. Joint stiffness was investigated with both materials and reported here. The results shows that the proposed variable stiffness joints with TRF achieve wide ranges of load-deflection ratio varying between 0.05 N/mm (when thermally activated) to about 10 N/mm (in bonding state). On average, the joint can withstand 20 times its total weight when in the bonding state. Design challenges and durability of TRF-based joints are discussed.