With the development of high-volume manufacturing for very-large-scale integrated circuits, the purity of the light source in the extreme ultraviolet lithography (EUVL) system needs to fulfil extreme requirements in order to avoid thermal effect, optical distortion and critical dimension errors caused by out-of-band radiations. This paper reviews the key technologies and developments of the spectral purity systems for both a free-standing system and a built-in system integrated with the collector. The main challenges and developing trends are also discussed, with a view towards practical applications for further improvement. Designing and manufacturing spectral purity systems for EUVL is not a single task; rather, it requires systematic considerations for all relevant modules. Moreover, the requirement of spectral purity filters drives the innovation in filtering technologies, optical micromachining and advanced metrology.
In this study, an extreme ultraviolet (EUV) conversion efficiency (CE) of 6.9% was obtained in simulation by controlling the delay between a picosecond pre-pulse and a main-pulse with a wavelength of 2 μm; this value is about 7.5% higher than the ns pre-pulse scheme of the EUV emission produced by a 2 μm laser-driven tin-droplet target. In the simulation, the tin droplet expanded into hollow spherical structures after irradiation with a picosecond pre-pulse laser. Notably, compared with a nanosecond pre-pulse, in this case, the density of the tin plasma was lower, and the expansion range was wider for the same delay. Therefore, ps pre-pulse can make the tin plasma reach the optimal state of EUV emission in a shorter delay. In both pre-pulse schemes, the CE value maintains a high value (>5.7%) within a certain delay range (800 ns) between pre-pulse and main-pulse. In this study, the FLASH radiation hydrodynamic code and FLYCHK atomic code were used to investigate the energy conversion and spectra. The results obtained can be potentially useful for EUV lithography under a two-pulse scheme.
Overlay (OVL) for patterns placed at two different layers during microchip production is a key parameter that controls the manufacturing process. The tolerance of OVL metrology for the latest microchip needs to be at nanometer scale. This paper discusses the influence on the accuracy and sensitivity of diffraction-based overlay (DBO) after developing inspection and after etching inspection by the asymmetrical deformation of the OVL mark induced by chemical mechanical polishing or etching. We show that the accuracy and sensitivity of DBO metrology can be significantly improved by matching the measuring light wavelength to the thickness between layers and by collecting high-order diffraction signals, promising a solution for future OVL metrology equipment.