A new bleaching agent consisting of a titanium dioxide photocatalyst and 3.5% hydrogen peroxide has recently been developed for in-office bleaching and has proven to react well with irradiated light...
19 June 2015 in Bio-Medical Materials and Engineering
The aim of this study was to investigate bonding effectiveness in direct restorations. A two-step self-etch adhesive and a light-cure resin composite was compared with luting with a conventional dual-cure resin cement and a two-step etch and rinse ad
Objective : This study evaluated the influence of laser irradiation with a high pulse repetition rate on dentin bonding. Background Data : Although resin bonding to erbium:yttrium-aluminium-garnet (Er:YAG) laserirradiated dentin has frequently been investigated, the effects of a high pulse repetition rate have not yet been sufficiently investigated. Methods : Four groups treated under different laser conditions were evaluated in this study: 100 mJ/pulse–10 pulses per second [pps], 50 mJ/pulse–20 pps, 33 mJ/pulse–30 pps, and the unlased condition as a control. The total energy used to irradiate each group was adjusted to 1.0 W. After bovine dentin specimens were irradiated by an Er:YAG laser, acid conditioners (10% citric acid/3% ferric chloride) were applied to the lased surface. Thereafter, a PMMA rod was bonded to the lased dentin using 4- META/MMA-TBB resin, and mini-dumbbell-shaped specimens were prepared. These specimens were then tested under tensile mode and fractured surfaces were observed under scanning electron microscopy (SEM). Results : The bond strength of the unlased control was significantly higher than those of the three lased groups. Among the three lased groups, irradiation with higher output energy and lower pulse repetition rate tended to affect the higher bond strength. Upon SEM observation of the fractured surface, the lased groups showed the mixture of failure in the hybrid layer in almost part. There was no significant difference among the three lased groups. Conclusion : It can be concluded from the results of this study that a higher pulse repetition rate is not effective for resin bonding to laser-irradiated dentin.
1 March 2011 in The Journal of the American Dental Association
This study compared surface roughness and gloss produced by different finishing/polishing procedures for two resin composites, Clearfil AP-X (AP-X) and Estelite Σ (ES). A total of 70 composite discs (n=35 for each resin composite) were prepared and divided at random into seven finishing/polishing groups (n=5): glass-pressed control; using a super-fine-grit diamond bur (SF); using CompoMaster (CM) after SF-finishing (SF+CM); using White Point (WP) after SF-finishing (SF+WP); using CM after SF+WP-finishing (SF+WP+CM); using Stainbuster (SB) after SF-finishing (SF+SB); and using CM after SF+SB-finishing (SF+SB+CM). After the finishing/polishing procedures, average surface roughness ( Ra ) and surface gloss (Gs(60 ° )) of all specimens were assessed with a surface profilometer and specimen gloss meter, respectively. Glass-pressed controls for both AP-X and ES composites showed the best surface finish in terms of both Ra and Gs(60 ° ). SF-finishing produced the roughest surface and led to almost complete loss of gloss. While additional polishing with CM reduced Ra and increased Gs(60 ° ), the additional finishing effect of WP or SB between SF-finishing and CM-polishing was not found for either AP-X or ES.