Biplab Paul

Dr. Biplab Paul

orcid

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2018 in Applied Materials Today
Verified
Journal Article
Open access
YDYong Du
Yong Du
JXJiayue Xu
Jiayue Xu
BPBiplab Paul
Biplab Paul
PEPer Eklund
Per Eklund

15 September 2010 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
BPBiplab Paul
Biplab Paul
AVAjay Kumar V
Ajay Kumar V
PBP. Banerji
P. Banerji
The concept of energy filtering of the carriers to control the thermoelectric properties of PbTe is experimentally applied in this present work. The energy barriers at the grain interfaces of the nanocomposites and the embedded Ag-rich nanodots within the grains are supposed to control the energy dependency of carrier scattering: that is what we mean by energy filtering of carriers. As a case study, vertical Bridgman grown bulk PbTe:undoped, PbTe:Ag crystals and nanocomposites of PbTe:Ag are used as samples. Thermoelectric properties of all the samples have been evaluated through temperature dependent electrical conductivity, Seebeck coefficient and room temperature Hall and thermal conductivity measurements. It is found that the PbTe:Ag nanocomposites has the highest power factor of 18.78×10−4 W m−1 K−2 with a room temperature thermal conductivity of 1.69 W m−1 K−1 . The crystal structures of these samples show the effective potential barrier at the grain boundaries and embedded nanodots within the grains to facilitate the energy filtering of the carriers.

24 July 2017 in ACS Applied Materials & Interfaces
Verified
Journal Article
Open access
BPBiplab Paul
Biplab Paul
JLJun Lu
Jun Lu
PEPer Eklund
Per Eklund
Because of their inherent rigidity and brittleness, inorganic materials have seen limited use in flexible thermoelectric applications. On the other hand, for high output power density and stability, the use of inorganic materials is required. Here, we demonstrate a concept of fully inorganic flexible thermoelectric thin films with Ca3Co4O9-on-mica. Ca3Co4O9 is promising not only because of its high Seebeck coefficient and good electrical conductivity but also because of the abundance, low cost, and nontoxicity of its constituent raw materials. We show a promising nanostructural tailoring approach to induce flexibility in inorganic thin-film materials, achieving flexibility in nanostructured Ca3Co4O9 thin films. The films were grown by thermally induced phase transformation from CaO–CoO thin films deposited by reactive rf-magnetron cosputtering from metallic targets of Ca and Co to the final phase of Ca3Co4O9 on a mica substrate. The pattern of nanostructural evolution during the solid-state phase transformation is determined by the surface energy and strain energy contributions, whereas different distributions of CaO and CoO phases in the as-deposited films promote different nanostructuring during the phase transformation. Another interesting fact is that the Ca3Co4O9 film is transferable onto an arbitrary flexible platform from the parent mica substrate by etch-free dry transfer. The highest thermoelectric power factor obtained is above 1 × 10–4 W m–1 K–2 in a wide temperature range, thus showing low-temperature applicability of this class of materials.

27 February 2014 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
PRP. K. Rawat
P. K. Rawat
BPBiplab Paul
Biplab Paul
PBP. Banerji
P. Banerji

27 June 2011 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
BPBiplab Paul
Biplab Paul
PRP. K. Rawat
P. K. Rawat
PBP. Banerji
P. Banerji
We report thermoelectric properties of PbTe doubly doped with chromium (Cr) and iodine (I). Cr is found to create a local enhancement of density of states (DOS) in the conduction band of PbTe, and I is found to tune the position of the Fermi level. The coincidence of the Fermi level with the enhanced DOS is found to produce up to 135% enhancement in thermopower leading to a high power factor (PF) of 56.16 × 10−4 Wm−1K−2 at 500 K. Such high value of power factor can produce thermoelectric figure of merit (ZT) above 2.

27 April 2018 in ACS Applied Energy Materials
Verified
Journal Article
Open access
BPBiplab Paul
Biplab Paul
Emma BjörkEmma Björk
Emma Björk
AKAparabal Kumar
Aparabal Kumar
JLJun Lu
Jun Lu
PEPer Eklund
Per Eklund
The development of high-performance and transferable thin-film thermoelectric materials is important for low-power applications, e.g., to power wearable electronics, and for on-chip cooling. Nanoporous films offer an opportunity to improve thermoelectric performance by selectively scattering phonons without affecting electronic transport. Here, we report the growth of nanoporous Ca3Co4O9 thin films by a sequential sputtering-annealing method. Ca3Co4O9 is promising for its high Seebeck coefficient and good electrical conductivity and important for its nontoxicity, low cost, and abundance of its constituent raw materials. To grow nanoporous films, multilayered CaO/CoO films were deposited on sapphire and mica substrates by rf-magnetron reactive sputtering from elemental Ca and Co targets, followed by annealing at 700 °C to form the final phase of Ca3Co4O9. This phase transformation is accompanied by a volume contraction causing formation of nanopores in the film. The thermoelectric propoperties of the nanoporous Ca3Co4O9 films can be altered by controlling the porosity. The lowest electrical resistivity is ∼7 mΩ cm, yielding a power factor of 2.32 × 10–4 Wm–1K–2 near room temperature. Furthermore, the films are transferable from the primary mica substrates to other arbitrary polymer platforms by simple dry transfer, which opens an opportunity of low-temperature use these materials.