In nanomedicine, physicochemical properties of the nanocarrier affect the nanoparticle's pharmacokinetics and biodistribution, which are also decisive for the passive targeting and nonspecific cellular uptake of nanoparticles. Size and surface charge are, consequently, two main determining factors in nanomedicine applications. Another important parameter which has received much less attention is the morphology (shape) of the nanocarrier. In order to investigate the morphology effect on the extent of cellular internalization, two similarly sized but differently shaped rod-like and spherical mesoporous silica nanoparticles were synthesized, characterized and functionalized to yield different surface charges. The uptake in two different cancer cell lines was investigated as a function of particle shape, coating (organic modification), surface charge and dose. According to the presented results, particle morphology is a decisive property regardless of both the different surface charges and doses tested, whereby rod-like particles internalized more efficiently in both cell lines. At lower doses whereby the shape-induced advantage is less dominant, charge-induced effects can, however, be used to fine-tune the cellular uptake as a prospective ‘secondary’ uptake regulator for tight dose control in nanoparticle-based drug formulations.
The development of high-performance and transferable thin-film thermoelectric materials is important for low-power applications, e.g., to power wearable electronics, and for on-chip cooling. Nanoporous films offer an opportunity to improve thermoelectric performance by selectively scattering phonons without affecting electronic transport. Here, we report the growth of nanoporous Ca3Co4O9 thin films by a sequential sputtering-annealing method. Ca3Co4O9 is promising for its high Seebeck coefficient and good electrical conductivity and important for its nontoxicity, low cost, and abundance of its constituent raw materials. To grow nanoporous films, multilayered CaO/CoO films were deposited on sapphire and mica substrates by rf-magnetron reactive sputtering from elemental Ca and Co targets, followed by annealing at 700 °C to form the final phase of Ca3Co4O9. This phase transformation is accompanied by a volume contraction causing formation of nanopores in the film. The thermoelectric propoperties of the nanoporous Ca3Co4O9 films can be altered by controlling the porosity. The lowest electrical resistivity is ∼7 mΩ cm, yielding a power factor of 2.32 × 10–4 Wm–1K–2 near room temperature. Furthermore, the films are transferable from the primary mica substrates to other arbitrary polymer platforms by simple dry transfer, which opens an opportunity of low-temperature use these materials.
In this study, mesoporous silica nanoparticles (MSPs) of different size and shape were developed, and their surface coatings were utilized to study their differential effects in enhancing antibacterial activity. In brief, MSPs with three different aspect ratios (1, 2 and 4) were prepared, doped with silver ions and finally coated with the polymer chitosan. Both Gram-positive and Gram-negative bacteria were treated with the MSPs. Results indicate that silver ion doped and chitosan coated MSPs with the aspect ratio of 4 (Cht/MSP4:Ag+) have the highest antimicrobial activity among the prepared series. Further studies revealed that Cht/MSP4:Ag+ was most effective against Escherichia coli (E.coli) and least effective against Vibrio cholerae (V. cholerae). To investigate the detailed inhibition mechanism of the MSPs, the interaction of the nanoparticles with E.coli membranes and its intracellular DNA was assessed using various spectroscopic and imaging-based techniques. Furthermore, to increase the efficiency of the MSPs, a combinatorial antibacterial strategy was also explored, where nanoparticles, in combination with kanamycin (antibiotic), were used against Vibrio Cholerae (V. cholerae). Toxicity screening of these on MSPs was conducted on Caco-2 cells, and the results show that the dose used for antibacterial screening is below the limit of the toxicity threshold. Our findings show that both shape and surface engineering contribute positively towards killing bacteria, and the newly developed silver ion-doped and chitosan-coated MSPs have good potential as antimicrobial nanomaterials.
The knowledge of how to control the pore size and morphology of separated mesoporous silica particles is crucial for optimizing their performance in applications, such as molecular sieves and drug delivery systems. In this work, we have systematically studied the effects of various synthesis parameters to gain a deeper understanding of how particle morphologies can be altered. It was found that the morphology for isolated particles of SBA-15 type, with unusually short and wide pores, could be altered from rods to platelets by variations in the NH4F concentration. The pore length is nearly constant (∼300 nm) for the different morphologies, but the particle width is increasing from 200 nm to >3 μm when decreasing the amount of NH4F, and the pore size can be tuned between 10 and 13 nm. Furthermore, other synthesis parameters such as heptane concentration, pH, silica precursor, and additions of ions have also been studied. The trend regarding particle width is independent of heptane concentration, at the same time as heptane increases the particle length up to a plateau value of ∼500 nm. In all, parameters controlling particle width, length, and pore size have been separated in order to evaluate their function in the particle formation. Additionally, it was found that the formation time of the particles is strongly affected by the fluoride ion concentration, and a mechanism for particle formation for this system, where micelles transform from a foam, to multilamellar vesicles, and finally to cylindrical micelles, is suggested.