Date palm leaves have been diachronically applied in building materials in the Middle East and North Africa (MENA) region, so as to enhance specific properties, such as volume stability and strength. This research work concerns an experimental study on the impact of date palm leaflet powder (DPLP) on the thermal and physico-mechanical properties of gypsum mortars. A series of mortar compositions were prepared with different proportions of DPLP (0, 1, 3, and 5% w/w of binder) and variant particle size (0.5, 1, and 1.5 mm). The results showed that the mortars containing DPLP exhibited significant changes in their properties due to variations in DPLP concentration and particle size. Increased DPLP led to lower density, higher porosity, and water absorption rate, whereas mechanical strength and thermal conductivity were decreased according to the DPLP proportion and size. This research provides valuable insights into the use of sustainable and renewable building materials, highlighting the benefits of exploiting agricultural waste in the constructional sector. The findings lay the groundwork for future research and innovation in environmentally friendly construction technologies.
In this paper, we numerically study the influence of the addition of parallelogram ribs and pie-shaped ribs in micro-channels on thermal exchange in three dimensions. We design four different silicon micro-channel heat sinks; the first and second cases without ribs, the third case with added pie-shaped ribs, and a fourth case containing parallelogram ribs. The main purpose of this research is to determine the best micro-channel heat sink in which the heat dissipation is sufficient to improve the heat exchange performance of the micro-channel, as well as to improve the cooling of the electronic components. A constant heat flux is applied to the bottom wall of the four micro-channels, and we use liquid diamond-water with a volume concentration of 5% diamond nanoparticles as a coolant, with a Reynolds number chosen between 200 and 600. The numerical results show that the Nusselt number (Nu) of the micro-channel that contains the parallelogram ribs is higher than that for the other cases, and it also yiels lower temperature values on the bottom wall of the substrate compared to the micro-channel containing pie ribs. When increasing the flow velocity, the thermal resistance of the micro-channel decreases in all cases, and we then find the largest value of the friction factor in the fourth case (with parallelogram ribs).
15 October 2019 in Journal of Thermal Science and Engineering Applications
In this work, a computational analysis of a spherical solar hot water storage tank during the discharging process is carried out by using the commercial code ansys-fluent.15. The study investigates a new type of spherical heat storage tank. A hinged baffle is fixed at the tank vertical axis to increase the discharge flow rate without a thermocline layer. The dynamic mesh LAYERING technique is used to update the computational domain during the movement of the hinged baffle. The passive pitching of the submerged baffle is due to the fluid-dynamic loads. This model limits the mixture between hot and cold water regardless of the inlet flow rate. A comparative study between tanks with typical diffusers and the hinged baffle model is considered. The comparison of the computational fluid dynamics results with available experimental data showed a good agreement. Examinations of the temperature contours indicate that for the typical models, the interaction between the incoming cold water and the stored hot water gives rise to a thick thermocline layer where its temperature and thickness are related to the intensity of the mixing process. The suggested model shows high stratification efficiency along the discharging process.