Conventional cooling channels used in die casting molds exhibit significant drawbacks, resulting in extended cooling times for cast parts. Issues such as the formation of dirt, limescale, and corrosion substantially diminish the thermal efficiency of these channels, leading to challenges in achieving uniform cooling and potential quality issues. In response to these challenges, this study proposes Topology Optimization as a novel approach. It involves designing cooling structures through Topology Optimization to replace traditional cooling channels, incorporating both Discrete and Gaussian boundary conditions to optimize thermal efficiency. Additionally, Structural Topology Optimization is employed to ensure structural integrity, preventing deformation or yielding under high loads during the die casting process. Numerical analysis revealed superior thermal performance compared to conventional channels, particularly when subjected to Discrete and Gaussian boundary conditions. Furthermore, the application of the latter establishes conformal cooling and minimizes temperature gradients in the casting, reducing casting defects such as shrinkage porosity. These findings highlight the efficacy of Topology Optimization in addressing the challenges of traditional cooling methods, with wide-ranging implications for manufacturing processes utilizing permanent molds for shaping materials.
Light metal foundries consume large amounts of energy and rely mainly on gas-fired melting, which is inefficient and promotes porosity caused by dissolved hydrogen. This pilot study examines local induction melting combined with ultrasonic melt treatment (UST) as a decentralized and electrified alternative. AlSi12 was cast with varied mold temperature, casting temperature, UST duration and remelted fraction. Porosity was characterized by optical microscopy in 2D and, for a subset of specimens, by X-ray computed tomography in 3D, and the mechanical behavior by tensile testing. An experimentally benchmarked simulation was used to estimate the energy demand for larger batch sizes. Including the energy required for cooling, the measured laboratory efficiency was 7.9% to 14.9%, and the simulation predicts 41.3% for 100 kg, or 48% with a preheated crucible, against 53.1% derived for industrial induction furnaces. Specimens treated with UST showed a lower mean porosity, 0.56% against 2.14% in optical microscopy and 0.153% against 0.367% in computed tomography, where the pore count was 73% lower at almost unchanged pore size. Their mean strain at fracture was 45.5% higher and their mean toughness 53.2% higher, whereas the 4.4% higher mean tensile strength lies within the scatter of the measurements.