Attapulgite (APT) is widely used in wastewater treatment due to its exceptional adsorption and colloidal properties, as well as its cost-effectiveness and eco-friendliness. However, low-grade APT generally limits its performance. Here, a colloid mill-assisted ultrasonic-fractional centrifugal purification method was developed to refine low-grade APT. This process successfully separated and removed impurity minerals such as quartz and dolomite from the raw ore, resulting in a refined APT purity increase from 16.9% to 60% with a specific surface area of 135.5 m2∙g−1. Further modifying of the refined APT was carried out through the hydrothermal method using varying dosages of cetyltrimethylammonium chloride (CTAC), resulting in the production of four different APT adsorbents denoted as QAPT-n (n = CTAC mole number) ranging from 0.5 to 5 mmol. Using Congo red (CR) as the target pollutant, the QAPT-5 sample exhibited the best adsorption capacity with the maximum quantity of 1652.2 mg∙g−1 in a neutral solution at 30 °C due to the highest surface charge (zeta potential = 8.25 mV). Moreover, the QAPT-5 pellets (~2.0 g adsorbent) shaped by the alginate-assisted molding method removed more than 96% of 200 mL aqueous solution containing 200 mg∙L−1 CR and maintained this efficiency in 10 adsorption–elution cycles, which exhibited the promising practical application.
1 September 2018 in Bioresource Technology Reports
Prussian blue (PB) is favored for its photothermal absorption capability in solar vapor generation applications. However, the photothermal conversion efficiency of current PB-based devices is limited by the material's poor dispersion. Herein, we report a method of incorporating PB in the interlayers of layered double hydroxides (LDHs) to prevent its aggregation. The dispersion is further enhanced and stabilized by the addition of sodium dodecyl sulfate (SDS). The thermal and water stability of PB is improved due to the rigid structure of LDHs and interactions between layers and anions. Elemental analysis confirms that with the increase of molar ratio of Mg/Al and the introduction of SDS, concentrations of PB are decreased accordingly. As a result, the rate of solar vapor generation is increased by 35.9% for powders containing 50 mg of equivalent PB. Of note, converting this material into a three-dimensional structure of high rebound foam further enhances solar water evaporation rate, from 0.79 kg m−2 h−1 to 0.98 kg m−2 h−1, with only 20 mg of equivalent PB, increasing the corresponding photothermal conversion efficiency from 53.8% to 66.3%.
Palygorskite (Pal) shows great potential for physical, chemical and biological uses due to its colloidal, catalytic and adsorption properties. Pal mines, however, are facing the challenge of low-grade materials (5–15%), making it difficult to use Pal in emerging fields such as new materials, environmental protection and health. Therefore, there is an urgent need to develop an efficient method for separating and purifying Pal to obtain high purity levels. Hence, we have developed a dispersant-assisted rotating liquid film reactor separation strategy based on sodium hexametaphosphate as the dispersant. This strategy utilizes the double electron layer of Pal and the density difference between impurities to achieve effective disaggregation and purification of Pal bundles through the promotion of repulsive driving effects. Under optimal conditions, the purity of Pal can be increased from less than 10% to over 80%. This research presents a novel approach to the efficient refining of low-grade Pal. The crudely purified Pal’s adsorption capacity for methylene blue increased from 84.2 to 256.4 mg g–1.