A computational fluid dynamics (CFD) study was conducted to investigate the effect of several important factors on the dust control performance of a down-the-hole (DTH) air hammer drill bit for reverse circulation drilling in mines. It was shown that an increasing number of suction nozzles or inclination angles of suction nozzles was advantageous to improve dust control performance of the drill bit. Lowering the location of suction nozzles in the drill bit body is another way to increase its ability to control dust. There exists a critical diameter of suction nozzles for dust control performance. A series of experimental tests in the laboratory were carried out to validate the results of CFD modelling. It was shown that the CFD simulation results were in good agreement with experimental data. A prototype of the drill bit was built for testing in laboratory experiments. The same prototype was field-tested by drilling vertically downward exploration boreholes in one of the largest Molybdenum Ore Districts in Luanchuan of Henan Province, China. Field test results indicate that the modified drill bit could control drilling dust effectively. No cuttings escaped from the borehole when it was used for downward drilling. The DTH air hammer drill bit has not been tested for drilling a vertically upward hole, and therefore, future studies are required to improve the suction capacity of the drill bit for drilling vertically upward holes.
1 July 2016 in Chemical Engineering Research and Design
Using a no-moving-component output-fed bistable fluidic oscillator to control fluid flows into a parallel path has been recognized for a considerable time, but as yet it is not so widely adopted as its obvious benefits would deserve. This may be attributed to the encountered problems associated with its jet behavior, complicated by its loading characteristics. In order to investigate a typical case for the application of the output-fed fluidic oscillator, this paper elaborates on the computational fluid dynamics (CFD) simulation method for studying the performance of a fluidic hammer controlled by an output-fed bistable fluidic oscillator. Given that couple mechanism exists between the flow field in the fluidic oscillator and the impact body, dynamic mesh technique and a user-defined function written in C programming language were used to update the mesh in the simulations. In terms of the evaluation of performance, the focus is on the single-impact energy and output power of the fluidic hammer in this study, to investigate the effect of different parameters of the impact body on them. Experimental tests based on the noncontact measuring method were conducted to verify the simulation results, by which the accuracy and reliability of this CFD simulation method was proved.
29 October 2021 in Rock Mechanics and Rock Engineering
An axial oscillation tool is proved to be effective in solving problems associated with high friction and torque in the sliding drilling of a complex well. The fluidic axial oscillation tool, based on an output-fed bistable fluidic oscillator, is a type of axial oscillation tool which has become increasingly popular in recent years. The aim of this paper is to analyze the dynamic flow behavior of a fluidic axial oscillation tool with the absence of a throttling plate in order to evaluate its overall performance. In particular, the differences between the original design with a throttling plate and the current default design are profoundly analyzed, and an improvement is expected to be recorded for the latter. A commercial computational fluid dynamics code, Fluent, was used to predict the pressure drop and oscillation frequency of a fluidic axial oscillation tool. The results of the numerical simulations agree well with corresponding experimental results. A sufficient pressure pulse amplitude with a low pressure drop is desired in this study. Therefore, a relative pulse amplitude of pressure drop and displacement are introduced in our study. A comparison analysis between the two designs with and without a throttling plate indicates that when the supply flow rate is relatively low or higher than a certain value, the fluidic axial oscillation tool with a throttling plate exhibits a better performance; otherwise, the fluidic axial oscillation tool without a throttling plate seems to be a preferred alternative. In most of the operating circumstances in terms of the supply flow rate and pressure drop, the fluidic axial oscillation tool performs better than the original design.