One of the concerns of underground CO2 onshore storage is the triggering of induced seismicity and fault reactivation by the pore pressure increasing. Hence, a comprehensive analysis of the tectonic parameters involved in the storage rock formation is mandatory for safety management operations. Unquestionably, active faults and seal faults depicting the storage bulk are relevant parameters to be considered. However, there is a lack of analysis of the active tectonic strain field affecting these faults during the CO2 storage monitoring. The advantage of reconstructing the tectonic field is the possibility to determine the strain trajectories and describing the fault patterns affecting the reservoir rock. In this work, we adapt a methodology of systematic geostructural analysis to underground CO2 storage, based on the calculation of the strain field from kinematics indicators on the fault planes (ey and ex for the maximum and minimum horizontal shortening, respectively). This methodology is based on a statistical analysis of individual strain tensor solutions obtained from fresh outcrops from the Triassic to the Miocene. Consequently, we have collected 447 fault data in 32 field stations located within a 20 km radius. The understanding of the fault sets' role for underground fluid circulation can also be established, helping further analysis of CO2 leakage and seepage. We have applied this methodology to Hontomín onshore CO2 storage facilities (central Spain). The geology of the area and the number of high-quality outcrops made this site a good candidate for studying the strain field from kinematics fault analysis. The results indicate a strike-slip tectonic regime with maximum horizontal shortening with a 160 and 50∘ E trend for the local regime, which activates NE–SW strike-slip faults. A regional extensional tectonic field was also recognized with a N–S trend, which activates N–S extensional faults, and NNE–SSW and NNW–SSE strike-slip faults, measured in the Cretaceous limestone on top of the Hontomín facilities. Monitoring these faults within the reservoir is suggested in addition to the possibility of obtaining a focal mechanism solutions for micro-earthquakes (M<3).
During the 2021 La Palma strombolian and fissure eruption, two faults were identified that controlled the spatial distribution of earthquake hypocenters and effusive eruptive vents. One of these faults has a NW-SE trend (Tazacorte Fault: TZF) and the other one shows an ENE-WSW trend (Mazo Fault: MZF). Previous works on fault structural analysis in La Palma indicated that the eruption zone was compatible with an extensional tectonic strain ellipsoid which activated normal-strike-slip directional faults at the confluence of TZF and MZF. These fractures were activated during the 2021 Tajogaite eruption, determining the NW-SE and WSW-ENE spatial distribution of vents. Both faults were mapped in real time during the volcanic eruption from fieldwork and remote sensing imagery (aerial drone images). We have collected more than 300 fracture data associated with the effusive vents and post-eruption seismic creep. Since the affected area was densely inhabited, most of these fractures affect houses and infrastructures. Some of the houses affected by the TZF were damaged 9 months after the eruption, although they were not damaged during the eruption. Surprisingly, these houses already had repairs made to the same fractures since 1980, giving information of previous fault creep movement. During the 2021 Tajogaite eruption, shallow seismicity was spatially related to both faults, suggesting a seismic behavior instead of the precedent creep movement. However, the lack of seismicity after the eruption indicates that the faults went back to creep aseismic behavior, similarly to 1980. The mapping and monitoring of these faults (TZF and MZF) is relevant bearing in mind that they have been active since 1980 and the post-eruptive phase of the 2021 volcanic eruption, which has to be included in the land use planning in areas affected by the volcanic eruption and creep movement. Furthermore, both faults could act as seismogenic sources triggering volcanic earthquakes with potential high macroseismic intensities and mass movements. The data presented here show the importance of having this type of study before the onset of the eruption, thus allowing a better interpretation of seismic data during volcanic unrest.