In this study, blends based on a high density polyethylene (HDPE) and chitosan (CS) were successfully prepared by melt processing, in a laboratory internal mixer. The CS biopolymer content effect (up to maximum of 40%), and, the addition of bentonite clay modified with quaternary ammonium salt (CTAB) impregnated chitosan as a compatibilizing agent, on the properties of the blends was analyzed by Fourier transform-infrared spectroscopy (FT-IR), wide angle X-ray diffraction (WAXD), differential scanning calorimetry (DSC), thermogravimetric analyses (TG), tensile strength, and scanning electron microscopy (SEM). The use of clay modified with CTAB impregnated chitosan, employing a method developed here, improved the compatibility of HDPE with chitosan, and therefore the thermal and some of the mechanical properties were enhanced, making HDPE/chitosan blends suitable candidates for food packaging. It was possible to obtain products of synthetic polymer, HDPE, with natural polymer, chitosan, using a method very used industrially, with acceptable and more friendly properties to the environment, when compared to conventional synthetic polymers. In addition, due to the possibility of impregnated chitosan with quaternary ammonium salt exhibit higher antibacterial activity than neat chitosan, the HDPE/chitosan/organobentonite blends may be potentially applied in food containers to favor the preservation of food for a longer time in comparison to conventional materials.

The global demand for food has been increasing, presenting new challenges in meeting this demand. To address this growing need, the use of coating technology through nanoemulsions shows great potential. The use of thyme essential oil stabilized by chitosan nanoparticles offers a promising and sustainable approach for the development of edible coatings. Chitosan was extracted from shrimp shell waste and used to produce nanoparticles via the ionotropic gelation method, using sodium tripolyphosphate (TPP) as a crosslinking agent. To prepare the nanoemulsions, thyme essential oil was used as the dispersed phase, combined with an aqueous phase containing chitosan nanoparticles and Tween 80 as the emulsifier. Two techniques were employed to produce nanoemulsions: high-pressure homogenization and ultrasonication. Nanoemulsion formulations with different concentrations were prepared and characterized in terms of droplet size (Z-Average) and stability using dynamic light scattering (DLS). The average droplet sizes obtained were above 100 nanometers for samples produced via high-pressure homogenization and below 100 nanometers for those prepared using ultrasonication. Analysis of variance (ANOVA) confirmed that both the method (p = 0.002) and the oil phase concentration (p < 0.001) had statistically significant effects on droplet size. Regression analysis showed that oil concentrations below 2.0 g (w/w) increased droplet size, while concentrations above 4.0 g (w/w) significantly reduced it (p < 0.05). However, physical stability tests conducted at 5 °C for 30 days showed consistent values across both formulations, with only minor fluctuations, suggesting overall good stability.