In this study, the sensing properties of an amorphous indium gallium zinc oxide (a-IGZO) thin film at ozone concentrations from 500 to 5 ppm were investigated. The a-IGZO thin film showed very good reproducibility and stability over three test cycles. The ozone concentration of 60–70 ppb also showed a good response. The resistance change (ΔR) and sensitivity (S) were linearly dependent on the ozone concentration. The response time (T90-res), recovery time (T90-rec), and time constant (τ) showed first-order exponential decay with increasing ozone concentration. The resistance–time curve shows that the maximum resistance change rate (dRg/dt) is proportional to the ozone concentration during the adsorption. The results also show that it is better to sense rapidly and stably at a low ozone concentration using a high light intensity. The ozone concentration can be derived from the resistance change, sensitivity, response time, time constant (τ), and first derivative function of resistance. However, the time of the first derivative function of resistance is shorter than other parameters. The results show that a-IGZO thin films and the first-order differentiation method are promising candidates for use as ozone sensors for practical applications.
We successfully fabricated a planar nanocomposite film that uses a composite of silver nanoparticles and titanium dioxide film (Ag-TiO2) for ultraviolet (UV) and blue light detection and application in ozone gas sensor. Ultraviolet-visible spectra revealed that silver nanoparticles have a strong surface plasmon resonance (SPR) effect. A strong redshift of the plasmonic peak when the silver nanoparticles covered the TiO2 thin film was observed. The value of conductivity change for the Ag-TiO2 composite is 4–8 times greater than that of TiO2 film under UV and blue light irradiation. The Ag-TiO2 nanocomposite film successfully sensed 100 ppb ozone. The gas response of the composite film increased by roughly six and four times under UV and blue light irradiation, respectively. We demonstrated that a Ag-TiO2 composite gas sensor can be used with visible light (blue). The planar composite significantly enhances photo catalysis. The composite films have practical application potential for wearable devices.
This study proposes a magnetic biochip that uses surface-enhanced Raman scattering (SERS) for antigen detection. The biochip was a sandwich structure containing alternating layers of gold and magnetic Fe2O3 nanoparticles. Both single (Au/Fe2O3/Au) and multilayer (Au/Fe2O3/Au/Fe2O3/Au) chips containing Fe2O3 nanoparticles were fabricated to detect bovine serum albumin (BSA). The single-layer chip detected the BSA antigen at a signal-to-noise ratio (SNR) of 5.0. Peaks detected between 1000 and 1500 cm−1 corresponded to various carbon chains. With more Fe2O3 layers, bond resonance was enhanced via the Hall effect. The distribution of electromagnetic field enhancement was determined via SERS. The signal from the single-layer chip containing Au nanoparticles was measured in an external magnetic field. Maximum signal strength was recorded in a field strength of 12.5 gauss. We observed peaks due to other carbon–hydrogen molecules in a 62.5-gauss field. The magnetic field could improve the resolution and selectivity of sample observations.
Ag 2 S@TiO 2 films was made as humidity sensors by SILAR method. The heterojunction and nano-silver improve the electrons transfer and increase the response and reaction rate. It also provides high gas selectivity to avoid effect of air pollution.
FeSeTe nanobridges of different widths have been fabricated on MgO substrates using focused ion beams. These nanobridges exhibit the Josephson effects. The current-voltage curves of junctions with 248–564 nm wide follow the resistively and capacitatively shunted junction model. Shapiro steps under microwave radiation were clearly observed in these nanobridges. The products of the critical current and normal state resistance (IcRn) are remarkably high. The temperature dependence of IcRn product followed the Ambegaokar-Baratoff (A-B) relation. The value of energy gap of FeSeTe calculated from the A-B relation is 3.5kBTc. The nanobridge junctions have a strong potential for high frequency applications.