In recent years, integration of solar photovoltaic (PV) systems into distribution networks has been increasing rapidly, as it has become the most promising renewable energy source (RES) in the transition of power generation from centralised to decentralised systems. With the power electronic (PE) interfaces that use high-frequency internal switching, all renewable energy sources are considered to be harmonic emitters, especially near switching frequencies, i.e., above 2 kHz. This paper evaluates the behaviour of high-frequency harmonics in the 2–20 kHz range due to the parallel operation of multiple solar PV inverters connected to a low-voltage (LV) network. The circulation current component that flows within the installation due to the low impedance paths at higher frequencies is analysed. Summation of high-frequency harmonic currents is observed with phase diversity analysis. The circulating current component can become 14 times higher than the grid current component at higher frequencies.

Supraharmonic emissions, referred to as voltage/current waveform distortions in the 2–150 kHz range, have been identified as an emerging power quality concern. With the increased number of non-linear devices connected to the power grid, such as photovoltaic inverter systems, supraharmonic disturbances are expected to increase. Despite being a source of supraharmonic emissions, power electronic equipment has become a ubiquitous technology due to recent advancements. Similarly, researchers around the world have started studying these emissions; however, complete systematic knowledge concerning supraharmonic emissions is yet to be achieved. This paper uniquely delves into characterising emissions using existing knowledge, significantly improving the understanding of their complex micro-level interactions and highlighting emerging challenges. The paper presents a comprehensive summary integrating existing studies on supraharmonic emissions in five key areas: emissions, propagation and attenuation, measurement techniques, modelling and simulation, and mitigation.

Solar PV inverters require output filters to reduce unwanted harmonics in their output, where LCL filters are a more economical choice than larger inductance-only filters. A drawback of these filters is that they can introduce power quality disturbances, especially at higher frequencies (above 2 kHz). This paper investigates and characterises the resonance phenomenon introduced by different filter types, i.e., LC or LCL, and identifies their behavioural change when combined with multiple parallel grid-tied PV inverter systems. MATLAB/Simulink modelling aspects of PV inverter systems related to resonance phenomenon are presented, including establishing resonance at a specific frequency where potentially large variations in the parameter selection across manufacturers may exist. In addition, a method is developed to establish output filter frequency response through measurements, which is used to develop validated solar PV harmonic models for high-frequency analysis. The low-frequency harmonic models can be used up to the resonant frequency where the current flowing through the filter capacitor is insignificant compared to the current flowing into the electricity network.