Designing stretchable and skin-conformal self-powered sensors for intelligent sensing and posture recognition is challenging. Here, based on a multi-force mixing and vulcanization process, as well as synergistically piezoelectricity of BaTiO3 and polyacrylonitrile, an all-in-one, stretchable, and self-powered elastomer-based piezo-pressure sensor (ASPS) with high sensitivity is reported. The ASPS presents excellent sensitivity (0.93 V/104 Pa of voltage and 4.92 nA/104 Pa of current at a pressure of 10–200 kPa) and high durability (over 10,000 cycles). Moreover, the ASPS exhibits a wide measurement range, good linearity, rapid response time, and stable frequency response. All components were fabricated using silicone, affording satisfactory skin-conformality for sensing postures. Through cooperation with a homemade circuit and artificial intelligence algorithm, an information processing strategy was proposed to realize intelligent sensing and recognition. The home-made circuit achieves the acquisition and wireless transmission of ASPS signals (transmission distance up to 50 m), and the algorithm realizes the classification and identification of ASPS signals (accuracy up to 99.5%). This study proposes not only a novel fabrication method for developing self-powered sensors, but also a new information processing strategy for intelligent sensing and recognition, which offers significant application potential in human—machine interaction, physiological analysis, and medical research.
The flexible pressure sensor has attracted much attention due to its wearable and conformal advantage. All the same, enhancing its electrical and structural properties is still a huge challenge. Herein, a flexible integrated pressure sensor (FIPS) composed of a solid silicone rubber matrix, composited with piezoelectric powers of polyacrylonitrile/Polyvinylidene fluoride (PAN/PVDF) and conductive silver-coated glass microspheres is first proposed. Specifically, the mass ratio of the PAN/PVDF and the rubber is up to 4:5 after mechanical mixing. The output voltage of the sensor with composite PAN/PVDF reaches 49 V, which is 2.57 and 3.06 times that with the single components, PAN and PVDF, respectively. In the range from 0 to 800 kPa, its linearity of voltage and current are all close to 0.986. Meanwhile, the sensor retains high voltage and current sensitivities of 42 mV/kPa and 0.174 nA/kPa, respectively. Furthermore, the minimum response time is 43 ms at a frequency range of 1–2.5 Hz in different postures, and the stability is verified over 10,000 cycles. In practical measurements, the designed FIPS showed excellent recognition abilities for various gaits and different bending degrees of fingers. This work provides a novel strategy to improve the flexible pressure sensor, and demonstrates an attractive potential in terms of human health and motion monitoring.
25 February 2022 in Science China Technological Sciences
Human–machine interaction is now deeply integrated into our daily lives. However, the rigidity and high-power supply of traditional devices limit their further development. Herein, a high-performance flexible piezoelectric sensor (HFPS) based on a novel zinc oxide/polyacrylonitrile/Ecoflex (ZnO/PAN/Ecoflex) composite membrane is proposed. Due to the synergistic piezoelectricity of ZnO and PAN, the output voltage/current of the HFPS is increased by 140%/100% compared to the pure Zno/Ecoflex composite membrane. Furthermore, the fabricated HFPSs also have excellent sensitivity, linearity, stability and flexibility under periodic pressure. On this basis, due to its flexibility, stretchability and battery-free characteristics, a self-powered HFPS-based intelligent glove is proposed to wirelessly control diverse electronic systems through human hand gestures. In the meanwhile, the intelligent glove has been successfully applied to car two-dimensional motion, light bulb control and fan control. With the advantages of simple operation, portability and low power consumption, the glove is expected to provide new application prospects for human–machine interaction systems.
13 March 2025 in Science China Technological Sciences
With the existing pressure sensors, it is difficult to achieve the unification of wide pressure response range and high sensitivity. Furthermore, the preparation of pressure sensors with excellent performance for sleep health monitoring has become a research difficulty. In this paper, based on material and microstructure synergistic enhancement mechanism, a hybrid pressure sensor (HPS) integrating triboelectric pressure sensor (TPS) and piezoelectric pressure sensor (PPS) is proposed. For the TPS, a simple, low-cost, and structurally controllable microstructure preparation method is proposed in order to investigate the effect of carbon nano-onions (CNOs) and hierarchical composite microstructures on the electrical properties of CNOs@Ecoflex. The PPS is used to broaden the pressure response range and reduce the pressure detection limit of HPS. It has been experimentally demonstrated that the HPS has a high sensitivity of 2.46 V/104 Pa (50–600 kPa) and a wide response range of up to 1200 kPa. Moreover, the HPS has a low detection limit (10 kPa), a high stability (over 100,000 cycles), and a fast response time. The sleep monitoring system constructed based on HPS shows remarkable performance in breathing state recognition and sleeping posture supervisory control, which will exhibit enormous potential in areas such as sleep health monitoring and potential disease prediction.