Vehicular ad-hoc communications rely on periodic broadcast beacons as the basis for most of their safety applications, allowing vehicles to be aware of their surroundings. However, an excessive beaconing load might compromise the proper operation of these crucial applications, especially regarding the exchange of emergency messages. Therefore, congestion control can play an important role. In this article, we propose joint beaconing rate and transmission power control based on policy evaluation. To this end, a Markov Decision Process (MDP) is modeled by making a set of reasonable simplifying assumptions which are resolved using Q-learning techniques. This MDP characterization, denoted as MDPRP (indicating Rate and Power), leverages the trade-off between beaconing rate and transmission power allocation. Moreover, MDPRP operates in a non-cooperative and distributed fashion, without requiring additional information from neighbors, which makes it suitable for use in infrastructureless (ad-hoc) networks. The results obtained reveal that MDPRP not only balances the channel load successfully but also provides positive outcomes in terms of packet delivery ratio. Finally, the robustness of the solution is shown since the algorithm works well even in those cases where none of the assumptions made to derive the MDP model apply.

Ascorbic Acid (AA) is a natural and powerful water-soluble antioxidant associated with long-lasting food products. As time passes, the AA content in products sharply decreases, and they become increasingly degraded. There are several techniques to precisely quantify AA concentrations. However, most of them employ costly laboratory instruments, such as High-Performance Liquid Chromatography (HPLC) or complex electrochemical methods, which make unfeasible recurrent AA measurements along the entire supply chain. To address this issue, we contribute with an in-field and real-time voltammetric method, carried out with a low-cost, easy-to-use, and portable device. An unmodified Screen-Printed Electrode (SPE) is used together with the device to achieve short reading times. Our method has been extensively tested in two multifruit juices using three different SPEs. Calibration curves and Limit of Detection were derived for each SPE. Furthermore, periodic experiments were conducted to study the shelf life of juices under consideration. During the analysis, a set of assays for each SPE were implemented to determine the remaining AA amount per juice and compare it with that obtained using HPLC under the same conditions. Results revealed that our cost-effective device is fully comparable to the HPLC equipment, as long as the juice does not include certain interferents; a scenario also contemplated in this article.