The suitability of various nitrogen, sulfur, oxygen, and phosphorus compounds as complexing agents in a silver electrolyte was examined by using potentiometric titration under practical conditions. The setup consisted of three electrodes to measure the pH and the activity of the silver ions simultaneously. Different ratios of silver to complexing agent from 1:10 to 1:1 at a constant ionic strength of 0.2 mol/L were investigated. The type of the complexes and their corresponding critical stability constants were evaluated by fitting the measured data using a self-developed algorithm. The pH and Nernst potential curve were calculated for the assumed complexes based on the law of mass action to find the best approximation. The correct definition of the occurring species is challenging and can lead to significant changes in the calculation of stability constants. For this reason, the measured silver potential curves were primarily used for the rating of the complexing agents. An evaluation of the measurements shows that the donor atom of the complexing agent and its ligand field strongly affected the stability and type of the complexes. Only a few complexing agents were found to be suitable for use in the cyanide-free silver electrolyte.
7 November 2024 in Journal of Applied Electrochemistry
Results of an investigation of the action of various pyridinic and acetylenic brighteners during the electrodeposition of nickel are reported here. The focus was on the qualitative and quantitative analysis of the individual compounds 1-(3-sulphopropyl)-pyridinium betaine (PPS) and sulphopropylated 2-butyne-1,4-diol (HBOPS) and their reaction products. High performance liquid chromatography (HPLC) with a mass spectrometric detector (HPLC-MS) and a diode array detector in the UV range (HPLC-UV) were used to examine the various additives and the cathodic reaction products. PPS is almost completely hydrogenated to the piperidine compound (3-piperidin-1-yl-propane-1-sulphonate, PIPS) at the catalytically active nickel electrode; as intermediate products, only tetrahydrogenated pyridine (THPPS) compounds occur in the solution, in low concentrations. The entire hydrogenation chain takes place on the surface; partially hydrogenated products are either not desorbed at all or only desorbed in small quantities. Further by-products are dimers and after ring cleavage a pentylamine derivative {3-(pentylamino)-1-propanesulphonic acid, PAPS}. Via the olefinic intermediate stage, the butynediol compound (HBOPS) reacts to become sulphopropylated butanediol. After elimination of water, this forms butanoxy-propanesulphonate in a further hydrogenation step. Graphical Abstract