Scale deposits can reduce equipment efficiency in the oil and petrochemical industry. The gamma attenuation technique can be used as a non-invasive effective tool for detecting scale deposits in petroleum pipelines. The goal of this study is to propose a dual-energy gamma attenuation method with radial basis function neural network (RBFNN) to determine scale thickness in petroleum pipelines in which two-phase flows with different symmetrical flow regimes and void fractions exist. The detection system consists of a dual-energy gamma source, with Ba-133 and Cs-137 radioisotopes and two 2.54-cm × 2.54-cm sodium iodide (NaI) detectors to record photons. The first detector related to transmitted photons, and the second one to scattered photons. The transmission detector recorded two signals, which were the counts under photopeak of Ba-133 and Cs-137 with the energy of 356 keV and 662 keV, respectively. The one signal recorded in the scattering detector, total counts, was applied to RBFNN as the inputs, and scale thickness was assigned as the output.

Radiation-based instruments have been widely used in petrochemical and oil industries to monitor liquid products transported through the same pipeline. Different radioactive gamma-ray emitter sources are typically used as radiation generators in the instruments mentioned above. The idea at the basis of this research is to investigate the use of an X-ray tube rather than a radioisotope source as an X-ray generator: This choice brings some advantages that will be discussed. The study is performed through a Monte Carlo simulation and artificial intelligence. Here, the system is composed of an X-ray tube, a pipe including fluid, and a NaI detector. Two-by-two mixtures of four various oil products with different volume ratios were considered to model the pipe’s interface region. For each combination, the X-ray spectrum was recorded in the detector in all the simulations. The recorded spectra were used for training and testing the multilayer perceptron (MLP) models. After training, MLP neural networks could estimate each oil product’s volume ratio with a mean absolute error of 2.72 which is slightly even better than what was obtained in former studies using radioisotope sources.

The main required organ of the biological system is the Central Nervous System (CNS), which can influence the other basic organs in the human body. The basic elements of this important organ are neurons, synapses, and glias (such as astrocytes, which are the highest percentage of glias in the human brain). Investigating, modeling, simulation, and hardware implementation (realization) of different parts of the CNS are important in case of achieving a comprehensive neuronal system that is capable of emulating all aspects of the real nervous system. This paper uses a basic neuron model called the Izhikevich neuronal model to achieve a high copy of the primary nervous block, which is capable of regenerating the behaviors of the human brain. The proposed approach can regenerate all aspects of the Izhikevich neuron in high similarity degree and performances. The new model is based on Look-Up Table (LUT) modeling of the mathematical neuromorphic systems, which can be realized in a high degree of correlation with the original model. The proposed procedure is considered in three cases: 100 points LUT modeling, 1000 points LUT modeling, and 10,000 points LUT modeling. Indeed, by removing the high-cost functions in the original model, the presented model can be implemented in a low-error, high-speed, and low-area resources state in comparison with the original system. To test and validate the proposed final hardware, a digital FPGA board (Xilinx Virtex-II FPGA board) is used. Digital hardware synthesis illustrates that our presented approach can follow the Izhikevich neuron in a high-speed state (more than the original model), increase efficiency, and also reduce overhead costs. Implementation results show the overall saving of $84.30\%$ in FPGA and also the higher frequency of the proposed model of about 264 MHz, which is significantly higher than the original model, 28 MHz.

We evaluate the performance of different optimization techniques developed in the context of optical flow computation with different variational models. In particular, based on truncated Newton (TN) methods that have been an effective approach for large-scale unconstrained optimization, we develop the use of efficient multilevel schemes for computing the optical flow. More precisely, we compare the performance of a standard unidirectional multilevel algorithm—called multiresolution optimization (MR/Opt)—with that of a bidirectional multilevel algorithm—called full multigrid optimization (FMG/Opt). The FMG/Opt algorithm treats the coarse grid correction as an optimization search direction and eventually scales it using a line search. Experimental results on three image sequences using four models of optical flow with different computational efforts show that the FMG/Opt algorithm outperforms both the TN and MR/Opt algorithms in terms of the computational work and the quality of the optical flow estimation.

In this paper, the feasibility of using an X-ray tube instead of radioisotope sources for measuring volume fractions of gas, oil, and water in two typical flow regimes of three-phase flows, namely, annular and stratified, is evaluated. This study’s proposed detection system is composed of an X-ray tube, a 1 inch × 1 inch NaI detector, and one Pyrex-glass pipe to model different volume fractions for two flow regimes, annular and stratified. Group method of data handling (GMDH), a powerful regression tool, was also implemented to analyze the obtained data. The obtained results in this work indicate that a simple system based on an X-ray tube and just one NaI detector could be a potential alternative to radioisotope-based systems for separate measurements of gas, oil, and water volume fractions in annular and stratified flow regimes of a three-phase flow.