The present study deals with the fabrication of polyvinyl alcohol composites reinforced with 10, 20, 30, 40, 50, 60, 70 wt% of date palm leaf fibers. Among these 60 wt% is providing good sound absorption because of the increase of porosity. Next to acoustic behaviour of composites analysed by varying thickness from 20-40mm by keeping density constant (60 wt %). An impedance tube setup is used for the measurement of the sound absorption coefficient. The sound absorption properties of composite samples increased significantly by increasing the thickness of materials with a constant density. Initially, sound absorption was measured without an air gap behind the samples and it was observed that date palm leaf fibers composite behaves like a good sound energy absorber in the frequency range of 1500-6300 Hz. Another experiment performed by introducing the air gap behind the samples varies from (10-30mm). This configuration dissipating more energy of sound waves as compared to without air gap because air is also absorbing some amount of energy. Air gap with this sample can be used as a new method for the fabrication of natural fiber-reinforced composites.
In this paper, the modeling of an industrial robot is presented. The simulation of an industrial robot is carried out using the ADAMS multibody system. The computer-aided design model of an industrial robot is imported into ADAMS. The imported model in ADAMS is prepared for the simulation by adding markers or frames to the rigid bodies of an industrial robot. The relationship between the rigid bodies is established by applying constraints in ADAMS. The STEP function from the function builder is used to move the rigid bodies of an industrial robot. The STEP function is an expression that uses the initial and final conditions to create a smooth motion. The joint limits of an industrial robot are specified in the STEP function to trace the path of an end-effector, which represents the workspace of an industrial robot. Furthermore, the pose of an industrial robot using STEP expression is investigated in the postprocessor.
Power electronics has the ability to control electric power in the most effective and economical way and it plays a leading role in the transmission, distribution and application of electrical power, However, the non-linear properties of power electronic devices add harmonics which greatly reduces the power efficiency and hence the Power quality has become the severe issue for both customers and utility. Many devices are designed to increase the efficiency of electricity at the customer end. Now a days, UPQC has proven to be an effective device used to alleviate power quality issues in the distribution network. It has the ability to eliminate both voltage and current based problems simultaneously. This paper presents, 3-phase 3-wires UPQC system and 3-phase 4-wires UPQC system modelled using MATLAB which is used to eliminate the power quality issues. The shunt APF of UPQC uses PQ-theory based control technique and nonlinear adaptive filter is used in the series APF of UPQC. The THD analysis is used to determine the efficiency of UPQC. On comparing the results, it can be seen that the THD value with UPQC is less, suggesting an increase in power efficiency.