Composite slab has extensive application in building industrialization. In this study, a novel composite slab with a joint was proposed, where the precast planks with bent-up rebar are only partially prefabricated along the thickness direction at the joint for cast-in-site pouring of concrete, and the rest is fully prefabricated in the factory. The flexural performance of the composite slab was compared with that of a traditional cast-in-site slab with the same geometric dimensions through four-point bending test. The results demonstrate that the bending performance of the composite slab, including cracking load, yield load, and ultimate load, is basically consistent with that of the cast-in-site slab, and can meet the engineering requirements. Based on experimental results, numerical research was conducted on the composite slabs. The effects of slab thickness, diameter of steel bar, concrete strength of precast plank, and slab span on the flexural behavior of composite slab were investigated. The numerical results show that the cracking load, yield load, and load corresponding to the deflection limit of the specimen increase with the increase in slab thickness and decrease with the increase in slab span. Increasing the steel bar diameter can increase the load corresponding to the deflection limit and yield load, while the effect on the cracking load is almost negligible. The concrete strength of precast plank has no significant effect on the flexural behavior of the composite slab.
This study proposes a new type of composite slab with a separate joint, which not only improves the assembly rate but also enables unsupported construction. A static loading test was conducted to investigate the bending behavior of the composite slab with a separate joint under a distributed load. The test results showed that the test composite slab had good integrity and crack resistance. The separate joint can effectively transmit internal forces and conform to the requirements of practical engineering. In addition, a finite element model was developed for the composite slab. The experimental load and numerical load corresponding to the longitudinal crack penetrating the bottom surface of the slab were 9.0 kN/m2 and 8.6 kN/m2, respectively, with an error of less than 5%. It was demonstrated that the finite element model can accurately predict the mechanical behavior of the composite slab.