In this study, the charge transport mechanism of Pd/Si-based FS-GaN Schottky diodes was investigated. A temperature-dependent current–voltage analysis revealed that the I-V characteristics of the diodes show a good rectifying behavior with a large ratio of 103–105 at the forward to reverse current at ±1 V. The interface states and non-interacting point defect complex between the Pd metal and FS-GaN crystals induced the inhomogeneity of the barrier height and large ideality factors. Furthermore, we revealed that the electronic conduction of the devices prefers the thermionic field emission (TFE) transport, not the thermionic emission (TE) model, over the entire measurement conditions. The investigation on deep level transient spectroscopy (DLTS) suggests that non-interacting point-defect-driven tunneling influences the charge transport. This investigation about charge transport paves the way to achieving next-generation optoelectronic applications using Si-based FS-GaN Schottky diodes.
In this study, the effect of atmospheric hydrogen plasma treatment on the in-plane conductivity of solution-processed zinc oxide (ZnO) in various environments is reported. The hydrogen-plasma-treated and untreated ZnO films exhibited ohmic behavior with room-temperature in-plane conductivity in a vacuum. When the untreated ZnO film was exposed to a dry oxygen environment, the conductivity rapidly decreased, and an oscillating current was observed. In certain cases, the thin film reversibly ‘switched’ between the high- and low-conductivity states. In contrast, the conductivity of the hydrogen-plasma-treated ZnO film remained nearly constant under different ambient conditions. We infer that hydrogen acts as a shallow donor, increasing the carrier concentration and generating oxygen vacancies by eliminating the surface contamination layer. Hence, atmospheric hydrogen plasma treatment could play a crucial role in stabilizing the conductivity of ZnO films.
A solid polymer electrolyte based on a poly(ethylene oxide)–poly(ethylene glycol dimethyl ether) (PEO-PEGDME) blend with LiTFSI was prepared and evaluated for Li-ion batteries. Three electrolytes (PEO:PEGDME = 20:80, 30:70, and 40:60 wt.%, denoted P2PE8, P3PE7, and P4PE6) were examined. Blending PEGDME suppressed PEO crystallization and enlarged the amorphous fraction available for ion transport, giving room-temperature ionic conductivities of 1.9 × 10-4, 3.7 × 10-4, and 3.6 × 10-4 S/cm at 295 K, respectively. Pulsed-field-gradient NMR yielded a Li⁺ transference number of 0.39 for the optimized P3PE7 membrane. The methoxy termini of PEGDME extended the electrochemical stability window of the membranes to 4.3–4.5 V. In LFP||PPE||Li metal half-cells, the P3PE7 electrolyte retained 92.7% of its initial capacity after 150 cycles with a low hysteresis voltage of ~0.16 V. These results show that the PEO-PEGDME blend is a promising solid polymer electrolyte for Li-ion batteries.