We investigate the stress evolution of 400 µm-thick freestanding GaN crystals grown from Si substrates by hydride vapour phase epitaxy (HVPE) and the in situ removal of Si substrates. The stress generated in growing GaN can be tuned by varying the thickness of the MOCVD AlGaN/AlN buffer layers. Micro Raman analysis shows the presence of slight tensile stress in the freestanding GaN crystals and no stress accumulation in HVPE GaN layers during the growth. Additionally, it is demonstrated that the residual tensile stress in HVPE GaN is caused only by elastic stress arising from the crystal quality difference between Ga- and N-face GaN. TEM analysis revealed that the dislocations in freestanding GaN crystals have high inclination angles that are attributed to the stress relaxation of the crystals. We believe that the understanding and characterization on the structural properties of the freestanding GaN crystals will help us to use these crystals for high-performance opto-electronic devices.
In this study, the charge transport mechanism of Pd/Si-based FS-GaN Schottky diodes was investigated. A temperature-dependent current–voltage analysis revealed that the I-V characteristics of the diodes show a good rectifying behavior with a large ratio of 103–105 at the forward to reverse current at ±1 V. The interface states and non-interacting point defect complex between the Pd metal and FS-GaN crystals induced the inhomogeneity of the barrier height and large ideality factors. Furthermore, we revealed that the electronic conduction of the devices prefers the thermionic field emission (TFE) transport, not the thermionic emission (TE) model, over the entire measurement conditions. The investigation on deep level transient spectroscopy (DLTS) suggests that non-interacting point-defect-driven tunneling influences the charge transport. This investigation about charge transport paves the way to achieving next-generation optoelectronic applications using Si-based FS-GaN Schottky diodes.
We investigate the electrical characteristics of Schottky contacts for an Au/hydride vapor phase epitaxy (HVPE) a-plane GaN template grown via in situ GaN nanodot formation. Although the Schottky diodes present excellent rectifying characteristics, their Schottky barrier height and ideality factor are highly dependent upon temperature variation. The relationship between the barrier height, ideality factor, and conventional Richardson plot reveals that the Schottky diodes exhibit an inhomogeneous barrier height, attributed to the interface states between the metal and a-plane GaN film and to point defects within the a-plane GaN layers grown via in situ nanodot formation. Also, we confirm that the current transport mechanism of HVPE a-plane GaN Schottky diodes grown via in situ nanodot formation prefers a thermionic field emission model rather than a thermionic emission (TE) one, implying that Poole–Frenkel emission dominates the conduction mechanism over the entire range of measured temperatures. The deep-level transient spectroscopy (DLTS) results prove the presence of noninteracting point-defect-assisted tunneling, which plays an important role in the transport mechanism. These electrical characteristics indicate that this method possesses a great throughput advantage for various applications, compared with Schottky contact to a-plane GaN grown using other methods. We expect that HVPE a-plane GaN Schottky diodes supported by in situ nanodot formation will open further opportunities for the development of nonpolar GaN-based high-performance devices.
We demonstrate a 400 μm-thick GaN layer on 4 inch (0001) Al2O3 substrates through GaN nanodot formation as a seed for stress relaxation layers, which were formed by an in situ special surface treatment using HVPE. The size and density of the GaN nanodots determined the thickness of the stress relaxation layers and the structural properties of thick GaN. The 400 μm-thick GaN layer exhibits a smooth surface and high crystal quality with FWHM of 104 arcsec and 163 arcsec in the (002) and (102) X-ray rocking curves, respectively. The dislocation density estimated via micro-PL measurements was 2 × 106 cm−2. This can provide an efficient and simple way to fabricate thick GaN layers on an Al2O3 substrate without ex situ buffer layer formation or additional complicated processes.
We demonstrated 5 mm-thick bulk gallium nitride (GaN) with nearly perfect crystal quality. To achieve this, intentional etch pit formation by in situ dry HCl etching and ex situ wet etching in H3PO4 solution was employed on freestanding GaN templates followed by regrowth by hydride vapor phase epitaxy (HVPE). This consecutive etching gave rise to a number of large and deep etch pits on the whole surface of the freestanding GaN. We believe that these can reveal the etch pits originating from the dislocations with the edge, and mixed components. Intentionally formed etch pits were partially covered with the fresh regrown bulk GaN layer, being transformed into voids. Dislocations cannot propagate into new GaN layers through the voids, thus resulting in the reduction of dislocation density. 5 mm-thick bulk GaN exhibits a smooth, transparent surface and extremely high crystal quality with full width at half maximum (FWHM) of 21 arcsec in (0002) X-ray rocking curve and etch pit density (EPD) of 3 × 102 per cm2. This method can provide a promising way to fabricate bulk GaN with extremely low dislocation density, suitable for the fabrication of high-performance devices.
We report on the defect states incorporated in a-plane GaN crystals grown on r-plane sapphire substrates by hydride vapor phase epitaxy (HVPE), using deep level transient spectroscopy (DLTS). Two defect states were observed at 0.2 eV and 0.55 eV below the conduction band minimum with defect densities of 5 × 1012/cm3 and 4.7 × 1013/cm3, respectively. The size of capture cross section, non-linear relation of trap densities from the depth profile, filling pulse width, and PL measurements indicated that the electronic deep trap levels in a-plane GaN on r-plane sapphire by HVPE originated from non-interacting point defects such as NGa, complex defects involving Si, O, or C, and VGa-related centres. Even though the a-plane GaN templates were grown by HVPE with high growth rates, the electronic deep trap characteristics are comparable to those of a-plane GaN layers of high crystal quality grown by MOCVD. This study prove that the growth of a-plane GaN templates on r-plane sapphire by HVPE is a promising method to obtain a-plane GaN layers efficiently and economically without the degradation of electrical characteristics.