La atención a la evacuación del agua de lluvia y a la protección de la estructura ante los agentes meteorológicos ha dado lugar a un conjunto de propuestas de estructuras desplegables de aspas sobre planta rectangular en las que estas estructuras definen limas y faldones de pendiente suficiente. El trabajo parte de la resolución del trazado de estructuras desplegables de aspas planas simétricas y base cuadrangular con directriz quebrada, garantizándose el correcto funcionamiento cinemático mediante la construcción de modelos. Se estudian desplegables con directrices poligonales, curvas compuestas y también combinaciones de curvas y rectas. Se repasan los problemas de estabilización de la solución en el estado desplegado, incorporando la cobertura textil y cables de arriostramiento. Finalmente se desarrollan y analizan geométrica y cinemáticamente una serie de propuestas con superficies de intradós y extradós diferentes y otro grupo de ellas en las que los sentidos de despliegue no siguen los ejes del recinto a cubrir.
29 October 2015 in VLC arquitectura. Research Journal
The Galerie des Machines of 1889 is present in most books on the history of architecture. There are, however, certain aspects of this building that merit a more in-depth study. Other elements have been incorrectly described in current and contemporary publications about the building. The aim of this article is to examine the place this building occupies in the historical development of metal arch structures, its precedents and the influence it has exerted on later buildings of a similar structure. On the other hand, there have also been contradictions concerning the materials used in the erection of the structure and the reasons behind using them, as well as the exact span achieved. This article will unequivocally resolve these issues.
In this article, deployable cylindrical vaults of reciprocal linkages with frustoconical ends are analysed. Deployable cylindrical vaults with quadrangular scissors modules have low stiffness in the longitudinal direction, which requires the use of stiffening bars after deployment. The truncated cone-shaped ends improve their stiffness but do not prevent bracing. However, if reciprocal knots are used, the mesh performance improves considerably. This article studies the design conditions of these vaults and their resistance to gravity, wind suction and wind loads in the transverse and longitudinal directions. We also study the different resistance behaviour of the mesh, depending on whether the roof is supported on the upper or lower joints. In all cases, model tests are carried out to check the validity of the proposed solutions. Both theoretical calculations and experimental tests demonstrate the viability and effectiveness of this type of structure.