Regardless of the long record of research works based on microbiologically influenced corrosion (MIC), its principle and mechanism, which lead to accelerated corrosion, is yet to be fully understood. MIC is observed on different metallic substrates and can be caused by a wide variety of microorganisms with sulfate-reducing bacteria (SRB) being considered the most prominent and economically destructive one. Copper and its alloys, despite being used as an antimicrobial agent, are recorded to be susceptible to microbial corrosion. This review offers a research overview on MIC of copper and its alloys in anaerobic aqueous environments. Proposed MIC mechanisms, recent work and developments as well as MIC inhibition techniques are presented focusing on potable water systems and marine environment. In the future research perspectives section, the importance and possible contribution of knowledge about intrinsic properties of substrate material are discussed with the intent to bridge the knowledge gap between microbiology and materials science related to MIC.
1 January 2018 in International Journal of Hydrogen Energy
The effect of varying surface roughness on microbiologically influenced corrosion by a model sulfate reducing bacterium Oleidesulfovibrio alaskensis G20 culture on copper 101 coupons was investigated using microscopic, spectroscopic and surface characterization techniques. After 7-day of anoxic exposure abundant biodeposits consisting of sessile cells and copper sulfide minerals were found and pitting attack was observed upon their removal. Results showed that the distribution and thickness of the biodeposits as well as the pitting severity were affected by the varying surface roughness. A direct relationship between surface roughness and microbial activity was not observed. However, a statistically significant reduction in the corrosion rate was recorded when the surface roughness was decreased from ∼2.71 μm to ∼0.006 μm.
1 October 2021 in Journal of Testing and Evaluation
Fiber reinforced polymer composites are often used as a replacement for metal alloys because of the superior strength to weight ratio. However, a major drawback of these materials is the lack of formability caused by the low strain to failure ratio that does not allow the material to follow tooling contours into deep drawn shapes or tight radii. Composite materials have a multiscale hierarchical structure where micro and meso scale effects (fiber and tow scales) contribute to the macro structural response (laminate scale). In particular, during forming, different deformation occurs simultaneously at every scale. Currently, the amount of quantifiable and comparable forming data for both continuous and discontinuous fiber reinforced polymer composites, including a multi-scale understanding of the deformation response, is limited because of the lack of a testing system. This article proposes a novel test method and an apparatus called “the forming fixture” for testing the tow formability of fiber reinforced polymer composites by determining the required load to form an uncured resin impregnated fiber tow sample into a stretch drawn profile. Test results from forming of Hexcel (Stamford, CT) IM7-G continuous carbon fiber impregnated with Huntsman (The Woodlands, TX) RDM 2019-053 resin system, in the temperature range of 21°C–121°C, are discussed to demonstrate the use of the proposed apparatus including representative data. Results showed consistency and repeatability, validating the reliability of the novel method. The test aided in defining the forming behavior of the material in real time both visually (e.g. sample failure location) and as forming load versus displacement curves. A novel forming metrics, relating the maximum drawing depth with no failure and the maximum forming load, is defined to compare and select different fiber and resin formulations. Widespread adoption of the forming fixture will reduce reliance on a “trial and error” approach during the the forming process.
20 February 2023 in International Journal of Material Forming