Molecules intercalating two-dimensional materials form complex structures that have been characterized primarily by spatially averaged techniques. Here we use aberration-corrected scanning transmission electron microscopy and density-functional-theory (DFT) calculations to study the atomic structure of bilayer graphene (BLG) and few-layer graphene (FLG) intercalated with . In BLG, we discover two distinct intercalated structures that we identify as monolayer and monolayer . The two structures are separated by atomically sharp boundaries and induce large free-carrier densities on the order of in the graphene layers. In FLG, we observe multiple layers stacked in a variety of possible configurations with respect to one another. Finally, we find that the microscope's electron beam can convert the monolayer into FeOCl monolayers in a rectangular lattice. These results reveal the need for a combination of atomically resolved microscopy, spectroscopy, and DFT calculations to identify intercalated structures and study their properties.
A point source interferometer (PSI) is a device where atoms are split and recombined by applying a temporal sequence of Raman pulses during the expansion of a cloud of cold atoms behaving approximately as a point source. The PSI can work as a sensitive multi-axes gyroscope that can automatically filter out the signal from accelerations. The phase shift arising from the rotations is proportional to the momentum transferred to each atom from the Raman pulses. Therefore, by increasing the momentum transfer, it should be possible to enhance the sensitivity of the PSI. Here, we investigate the degree of enhancement in sensitivity that could be achieved by augmenting the PSI with large momentum transfer (LMT) employing a sequence of many Raman pulses with alternating directions. We analyze how factors such as Doppler detuning, spontaneous emission, and the finite initial size of the atomic cloud compromise the advantage of LMT and how to find the optimal momentum transfer under these limitations, with both the semi-classical model and a model under which the motion of the center of mass of each atom is described quantum mechanically. We identify a set of realistic parameters for which LMT can improve the PSI by a factor of nearly 40.
23 June 2015 in International Journal of Modern Physics B
We analyze theoretically the sensitivity of accelerometry and rotation sensing with a point source interferometer employing large momentum transfer (LMT) and present a design of an inertial measurement unit (IMU) that can measure rotation around and acceleration along each of the three axes. In this design, the launching technique is used to realize the LMT process without the need to physically change directions of the Raman pulses, thus significantly simplifying the apparatus. We also describe an explicit scheme for such an IMU.
In this paper, we present the experimental observation of simultaneous bi-directional superluminal lasing in a triangular ring cavity without gain competition and crosstalk as needed for realizing a gyroscope based on the Sagnac effect. The gain spectrum for each of the lasers is tailored to be a narrow dip on top of a broad gain using two stable isotopes of Rb. Specifically, we make use of 85Rb to produce a broad gain spectrum via the optically pumped Raman gain process and 87Rb to produce a narrow absorption spectrum via the optically pump Raman depletion process. A separate gain cell is used for the laser in each direction. Inferred from the simulation, the spectral sensitivity enhancements of the clock-wise and counter-clock-wise superluminal ring lasers are ∼362 and ∼505, respectively, with the imbalance attributed to differences in pump powers.
A point source atom interferometer (PSI) is a device where atoms are split and recombined by applying a temporal sequence of Raman pulses during the expansion of a cloud of cold atoms behaving approximately as a point source. Unlike a conventional light pulse atom interferometer, the PSI can produce a signal that corresponds to multi-axis rotation only, independent of acceleration. In addition, it can be used to measure acceleration along one direction, independent of rotation. Here, we describe a modified PSI that can be used to measure multi-axis rotation and multi-axis acceleration. Specifically, this type of PSI can be used to measure two-axes rotation around the directions perpendicular to the light pulses, as well as the acceleration in all three directions, with only one pair of Raman beams. Using two pairs of Raman beams in orthogonal directions sequentially, such a scheme would enable the realization of a complete atom interferometric inertial measurement unit.