This paper presents 3D-printed micro-porous structures made of a Cu/PLA composite by using material extrusion 3D printing technology. A metallic filament made of 80% copper and 20% polylactic acid (PLA) was used for the 3D printing of the porous samples. We varied printing parameters, aiming to obtain a micro-range porosity that can serve as a water-filtering structure. The produced samples were analyzed from the aspects of dimensional accuracy, level of porosity, and capacity for water flow. Several samples were fabricated, and the water flow was exhibited for the samples with an approximate 100 µm size of the interconnected open porosity. The application of material extrusion 3D printing, as a cost-effective, widely available technology for producing micro-range porous structures, is still challenging, especially for interconnected predefined porosity with metal-based filaments. Our research showed that the optimization of 3D printing parameters can enable the fabrication of copper-based micro-porous structures, but further research is still needed.
Copolymer poly(D,L-lactide-co-glycolide) is used for obtaining the systems for controlled delivery of medicaments. Its specific characteristics make it suitable for various researches where its synthesis is performed in different ways. Using the system for controlled delivery of medicaments, an equal concentration of the medicament is achieved in the body throughout an extended period of time and it has advantages over the conventional methods. In this paper we present a new solvent/non-solvent chemical method for obtaining DLPLG nanospheres. In the experiment various stabilizers were used in order to examine their influence on morphological characteristics of DLPLG particles. The samples were characterized by Infrared Spectroscopy (IR), Differential Scanning Calorimetry (DSC), Scanning Electron Microscopy (SEM) and Stereological analysis.
22 November 2025 in Transactions of the Indian Institute of Metals
The high chromium white cast iron (HCWCI) has been in use for decades and is expected to remain popular due to its superb wear resistance. This wear resistant material is recognized for its superior hardness, toughness, and corrosion resistance. It is widely used in industries such as mining, cement, and power generation, where high abrasion and impact resistance are essential. The studies in this paper were conducted on an alloy containing 24.48% chromium, 2.66% carbon 1.32% molybdenum, 1.6% nickel, 0.99% silicon and 0.96% manganese. Mechanical and microstructural characterization was carried out on both as-cast samples and samples subjected to appropriate heat treatment (quenching 1000 oC/2h air cooling, quenching followed by tempering at 250oC/3h and quenching to -196oC in liquid nitrogen). Mechanical characterization involved measuring Vickers hardness and assessing toughness using Sarpi's pendulum. Hardness and toughness results of samples are correlated with the obtained microstructure. The applied heat treatment led to an increase in the hardness values, while toughness values remained largely unchanged, which is a consequence of the unmodified forms of the existing carbides. Various types of carbides (M3C and M7C3 type, but also for this alloy typical Mo2C carbide) can be observed through etching with Murakam's reagent.