Diamond-Like Carbon (DLC) coatings can reduce fluid friction in TEHL contacts (thermo-elastohydrodynamic lubrication) of meshing gears. This study investigates the influence of different base oils i.e., mineral, polyalphaolefin and polyglycol oil on the friction of DLC coated spur gears. Thereby, a transient TEHL simulation model based on the finite element based full-system approach coupled iteratively with the thermal equations is applied, considering mechanical and thermal properties of the DLC coatings. Results show a clear reduction of fluid friction in DLC coated gears for all considered lubricants. This can be traced back to higher TEHL temperatures for DLC coated gears, which is due to its low thermal inertia resulting in a thermal insulation effect.

Low-loss gears are an interesting design approach for increasing the efficiency and thermal load limits of gearboxes. The loss-optimized gear geometry concentrates sliding around the pitch point, which results in low load-dependent gear power losses. In this study, a method for modeling transient EHL (elastohydrodynamically lubricated) contacts in gear mesh considering mixed lubrication and thermal effects is introduced and applied to analyze the tribological behavior of a low-loss gear geometry. Special focus is placed on local frictional losses to analyze the role of the thermal effects of the gear mesh. Although a thermal reduction in fluid friction is observed, the overall effect on total frictional losses of the low-loss gear geometry is evaluated to be very small. The edge geometry strongly influences the lubricant film thickness and frictional power losses.

The application of polymers in power-transmitting machine elements, e.g., gears, is limited by moderate thermo-mechanical properties and the detrimental accumulation of contact heat, even with external lubrication. Hence, polymer rolling–sliding elements are often prone to thermo-mechanical overload or abrasive wear. Diamond-like carbon (DLC) coatings are well known from steel applications for enhancing wear resistance and reducing friction. Since preliminary results indicate promising results for such coatings for polymers as well, their influence on the behavior of lubricated polymer contacts is investigated by numerical simulation. For polymer–steel contacts, the mechanical and thermophysical properties of coating and polymer are varied. The contact geometry is dominated by a local conformity, in which most of the deformation is related to the polymer. The DLC coatings affect film thickness and hydrodynamic pressure only little even for untypical high coating thicknesses. In contrast, the contact temperature decreases already for very thin coatings due to enhanced heat removal. Hence, DLC coatings can act as a thermal barrier protecting the polymer from detrimental heat and protecting the polymer from abrasive wear.