Developing cost-effective electrocatalysts for the oxygen evolution reaction (OER) in proton exchange membrane (PEM) water electrolysis is crucial to achieving large-scale hydrogen production through water electrolysis. Here, we propose the utilization of a compound Er2O3 to enhance the catalytic performance of MnO2 in acidic OER. In situ Raman and DFT calculations reveal that Er2O3 not only suppresses the phase transition of MnO2 but also undergoes dissolution at the interface, thereby optimizing the structure of the active catalytic layer. The optimization of the Mn active site through the incorporation of robust Mn–O bonds in the catalytic interface layer, along with the accumulation of active MnO species during OER, are both pivotal factors for enhancing catalytic performance. Due to these inherent advantages, the MnO2@Er2O3 heterostructure catalyst exhibits a low overpotential of 342 ± 5 mV at a current density of 10 mA cm−2. The long-term stability test at a high current density of 50 mA cm−2 for 20 h exhibited no significant performance degradation. This study develops a cost-effective electrocatalyst for acidic OER and provides a new avenue for developing low-cost electrocatalysts for OER under acidic conditions in water electrolysis.
19 April 2023 in International Journal of Green Energy
On the basis of previous studies, a staggered honeycomb-like flow field with drop-shaped gas distribution zone is proposed in this paper, and the staggered honeycomb-like flow channel can make the oxygen concentration higher, and the drop-shaped gas distribution zone can improve the uniformity of reaction gas in the flow field. A three-dimensional (3D), non-isothermal two-phase numerical model is established to study the flow field performance. First, the reaction gases in the flow field are analyzed, and it is found that the proposed flow field structure can effectively improve the concentration and uniformity of reactants. Second, the volume fraction of liquid water at the (GDL)/channel (CH) interface is analyzed, and it is found that compared with the model of the symmetrical honeycomb channel without considering the gas distribution zone, the proposed model has better water removal effect at the cathode. Finally, the effects of the proposed flow field structure on the membrane properties are discussed. In addition, the temperature uniformity and liquid water removal of PEMFC are improved under the condition of reverse flow of cathode and anode reaction gases. Graphical Abstract
30 March 2023 in International Journal of Energy Research
Passive thermal management using a phase-change material (PCM) for proton exchange membrane fuel cells (PEMFCs) has been proposed and widely used in the thermal management of Li-ion batteries. A three-dimensional and nonisothermal numerical model of a PEMFC with a PCM cooling channel (PCC) is established in this study. The PCC is better than an air-cooling channel (ACC) in terms of reactant distribution and water removal. Its temperature at the interface of the gas diffusion layer and catalyst layer is lower, and the uniformity of temperature is better. The peak current and power density of the PCC are 4.60% and 5.14% higher than those of the ACC, respectively. Furthermore, the PCC does not increase parasitic power, unlike the ACC. In addition, owing to the high temperature near the outlet, the cooling effects of filling 1/3 PCM and filling 2/3 PCM near the outlet and filling of all PCM are investigated, which shows that the filling of 2/3 PCM provides a better cooling performance.
1 January 2024 in International Journal of Energy Research
Gas starvation significantly affects the uniformity of stack. To reduce this phenomenon, a three‐dimensional, nonisothermal, and two‐phase full‐size liquid‐cooled stack model was developed, and the characteristics of the global and local nonuniformities of oxygen and liquid water in the flow field, membrane temperature, and current density were analyzed under sufficient oxygen supply and three different degrees of gas shortage. Advanced uniformity evaluation criteria (AUEC) were proposed to evaluate the overall uniformity of the stack, which can effectively characterize the local high nonuniformity of the cell units and the differences between edge and intermediate cell units. The results showed that with a decrease in cathode stoichiometric ratio, the AUEC of oxygen, liquid water, membrane temperature, and current density all decreased. The increase in the cooling liquid velocity increased the AUEC of the membrane temperature and current density in the stack, and the AUEC increased further when the oxygen supply was sufficient. In addition, the improvement scheme of GDL gradient porosity was proposed, which can effectively improve the uniformity of each parameter in the stack.
1 October 2019 in IOP Conference Series: Materials Science and Engineering
With the gradual increase of electricity demand in China, wind power and other power generation has developed rapidly, which makes the structure of power grid more complex. The complex structure increases the risk of short-circuit fault of power grid. The rapid development of wind power intensifies the randomness of power grid operation. This paper uses MATLAB/Simulink to model power system, construct simulation, and analyse the influence of grid-connected wind power and short-circuit faults on grid stability. The results show that the fluctuation and impact of the active power on the user side are significantly weakened compared with those of the single wind power grid when the high-power stable power supply is connected to the wind power grid. The single-phase short-circuit fault has no disturbance to the user of the grid, and the two-phase short-circuit and three-phase short-circuit have greater impact on the voltage, current and speed of the user end.
14 September 2022 in Korean Journal of Chemical Engineering