In the Inner Mongolia region, sand and dust storms are prevalent throughout the year, with sand erosion having a particularly significant impact on the performance of wind turbine blades. To enhance the performance stability of wind turbines and reduce operation and maintenance costs, this study delves into the specific impact of sand-laden wind erosion on the aerodynamic performance of scaled-down wooden wind turbine blades. The experiment conducts vehicle-mounted tests on scaled models of 1.5 MW wind turbine blades that have been eroded by wind-sand flows from different zones, analyzing the changes in aerodynamic performance of wind turbines caused by the erosion. The results indicate that with an increase in the angle of installation, both the overall power output and the wind energy utilization coefficient of the wind turbines show a declining trend. The power outputs of both the partially eroded group and the fully eroded group are unable to reach the rated power level of 100 W. Compared to the uneroded group, the leading-edge eroded group demonstrated higher power output and wind energy utilization coefficients across most wind speed ranges. This finding verifies the possibility that the drag-reducing effect caused by pits from leading-edge erosion has a positive impact on the aerodynamic performance of the blades. It also provides a new research perspective and strong evidence for the study of erosion effects on wind turbine blades and the optimization of their aerodynamic performance.
This study aims to characterize the emissions of ammonia (NH3) and methane (CH4) from naturally ventilated dairy barns located in cold regions during the winter season, thereby providing a scientific basis for optimizing dairy barn environmental management. The target barn was selected at a commercial dairy farm in Ulanchab, Inner Mongolia, China. Environmental factors, including temperature, humidity, wind speed, and concentrations of NH3, CH4, and CO2, were monitored both inside and outside the barn. The ventilation rate and emission rate were calculated using the CO2 mass balance method. Additionally, NH3 and CH4 emission prediction models were developed using the adaptive neural fuzzy inference system (ANFIS). Correlation analyses were conducted to clarify the intrinsic links between environmental factors and NH3 and CH4 emissions, as well as the degree of influence of each factor on gas emissions. The ANFIS model with a Gaussian membership function (gaussmf) achieved the highest performance in predicting NH3 emissions (R2 = 0.9270), while the model with a trapezoidal membership function (trapmf) was most accurate for CH4 emissions (R2 = 0.8977). The improved ANFIS model outperformed common models, such as multilayer perceptron (MLP) and radial basis function (RBF). This study revealed the significant effects of environmental factors on NH3 and CH4 emissions from dairy barns in cold regions and provided reliable data support and intelligent prediction methods for realizing the precise control of gas emissions.
Precise regulation of the postharvest storage environment is critical for reducing losses and maintaining potato quality. Semi-underground storage facilities are widely used in major potato-producing regions of northern China; however, pronounced spatiotemporal heterogeneity in the internal temperature field often leads to localized quality deterioration. To enable accurate sensing and proactive prediction of temperature dynamics in such facilities, this study investigated a typical semi-underground potato storage cellar in Wuchuan County, Inner Mongolia. A high-density sensor network was deployed to collect temperature data, and the spatiotemporal variation patterns of the internal temperature field were systematically analyzed. The results indicate that, at the same vertical height, spatial temperature gradually increases from the entrance toward the interior of the cellar. Both the maximum and minimum temperatures in the entrance zone are lower than those in other regions, while the highest temperatures are observed near the rear wall. Based on the collected data, hierarchical clustering was employed to partition the internal temperature field into three spatiotemporal pattern clusters with significant differences. Key representative monitoring locations were then identified using the Spearman correlation coefficient. An AdaBoost-based prediction model was subsequently developed to estimate the temperatures at other test locations within each cluster using measurements from the representative points. The results demonstrate that the proposed model maintains high prediction accuracy while substantially reducing dependence on a dense sensor network. The overall MAE ranges from 0.075 to 0.373 °C, and the sensor reduction ratio reaches 87%. This approach provides a paradigm for low-cost intelligent monitoring and offers theoretical support and decision-making guidance for the smart regulation of potato storage environments. By optimizing the monitoring of potato storage environments, this study can reduce monitoring system costs and resource consumption, providing technical support for building a sustainable potato supply chain and delivering significant economic benefits in promoting the development of a resource-conserving potato industry.
Ocean energy resources have abundant reserves and play an important role in addressing energy crises. The study simulated flow-induced vibration energy harvesting in an isosceles triangular structure composed of upstream fixed dual interfering cylinders and a downstream single-degree-of-freedom vibrating energy-harvesting cylinder, revealing that the presence of upstream interfering cylinders enhances marine energy capture. With the Reynolds number and spacing ratio fixed at 150 and L/D = 2, respectively, numerical simulations were performed for cases with different diameter ratios (D* = 1.0, 0.8, and 0.6), and wake visualization analysis was employed to illustrate the influence of vortex structures on structural vibrations. Parallel numerical analyses of a single energy-harvesting cylinder configuration were conducted to highlight the advantages of the dual interfering cylinder configuration in wake-excited energy harvesting. The results demonstrated that, under the wake excitation effects of the dual interfering cylinders, the dual interfering configuration exhibited significantly stronger flow-induced vibration energy-harvesting responses compared to the single energy-harvesting configuration, along with maintaining higher dimensionless amplitudes at elevated reduced velocities. Regarding energy harvesting performance, the dual interfering configuration showed high sensitivity-to-diameter ratio variations: The D* = 0.6 case achieved optimal energy-harvesting power and efficiency at reduced velocity (Ur) < 7, while at Ur > 7, the optimal diameter ratio shifted, with the D* = 1.0 configuration demonstrating superior capabilities. This research elucidates the influence mechanisms between multi-bluff-body wake-excited energy harvesting and diameter ratios, emphasizing the advantages of wake excitation in flow-induced vibration energy harvesting and establishes a technical foundation for the design of renewable marine energy harvesting devices based on multi-bluff-body wake excitation.