This paper introduces the Kuopio Tomography Challenge 2023 (KTC 2023), created to inspire and facilitate algorithm development for image reconstruction in electrical impedance tomography (EIT). A laboratory EIT dataset was prepared for the KTC 2023, using conductive and resistive inclusions of various shapes and sizes placed inside a shallow, circular water tank. The task for the competitors of the challenge was to produce segmented images of the inclusions from EIT data in cases of complete coverage of the tank surface with electrodes (lowest level of difficulty) and in cases of decreasing boundary coverage (corresponding to increasing level of challenge difficulty). A total of seven teams, with members from seven countries, participated in KTC 2023, submitting a total of 22 algorithms. The results of the competition show a variety of novel algorithms applied to real EIT data, with high quality image reconstructions from limited boundary data. The EIT data set collected for the challenge is publicly available for future studies on EIT image reconstruction.
There is an extensive need for surface sensors for applications such as tactile sensing for robotics, damage and strain detection for structural health monitoring and leak detection for buried structures. One type of surface sensor is electrical impedance tomography (EIT)-based sensing skins, which use electrically conductive coatings applied on the object’s surface to monitor physical or chemical phenomena on the surface. In this article, we propose a sensing skin with two electrically coupled layers separated by an insulator. Based on electrical measurements, the spatial distribution of the electrical coupling between the layers is estimated. This coupling is sensitive to both the pressure distribution on the surface and water entering between the layers through a leak. We present simulations and experimental studies to evaluate the feasibility of the proposed method for pressure sensing and leak detection. The results support the feasibility of the proposed method for both of these applications.
4 March 2025 in Measurement Science and Technology
Electrical impedance tomography (EIT) is an imaging modality based on applying electrical currents to the target object. Traditionally, both the magnitude and phase of electric potential measured on the target surface are required to reconstruct the admittivity, i.e. conductivity and permittivity, inside the target. However, measuring the phase of potential requires a more advanced EIT system than that used in amplitude data-based electrical resistance tomography. In this article, we propose a novel EIT method, amplitude-based multi-frequency EIT (AMFEIT), which reconstructs admittivity using only amplitude data. Therefore, AMFEIT can be used with devices that do not provide the phase data. The performance of AMFEIT is compared to that of traditional single frequency EIT using numerical and experimental tests. In simulations, the effects of certain modelling errors and choice of frequencies on the reconstruction quality are studied. In the experimental setup, several targets inside a water tank are imaged. Both the numerical and experimental tests support the feasibility of AMFEIT for reconstructing admittivity distributions. When the frequencies are properly chosen, the AMFEIT yields reconstructions that are of the same quality as those based on conventional EIT that uses phase data.
1 January 2024 in Applied Mathematics for Modern Challenges
Electrical impedance tomography (EIT) is an imaging modality based on electrical currents injected through the imaging domain and voltages measured on the boundary. It has a wide variety of applications ranging e.g. from medical imaging to industrial process monitoring. Computing the EIT reconstruction from the measurements is a severely ill-posed inverse problem, and hence it is not a straightforward task. Therefore, the EIT reconstruction algorithms remain an active area of research. To facilitate this research, we present in this article object-oriented EIT (OOEIT), an open source software package for MATLAB. It is designed for ease of use for those with no deep understanding of EIT, while also featuring a modular structure that allows for straightforward customization for those interested in developing their own algorithms. OOEIT includes implementations for both 2D and 3D computations, for both static and dynamic reconstructions, and supports user defined meshes. As examples, we present reconstructions computed from the Kuopio Tomography Challenge (KTC2023) data set.