Zhenning Li

Mr. Zhenning Li


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 June 2019 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
SLShouxiang Li
Shouxiang Li
ZLZhenning Li
Zhenning Li
SZShuhua Zheng
Shuhua Zheng
WXWenhao Xie
Wenhao Xie
YZYifei Zheng
Yifei Zheng
KSKeyue Ma Smedley
Keyue Ma Smedley
The Cuk dual resonance core (DRC) realizes overlapped dual resonance to regulate its output voltage. However, the DRC configuration was only applied to the Fibonacci switched-capacitor converter (SCC), series-parallel SCC and voltage doubler. In this paper, the Cuk DRC is modified and then is extended to the Dickson switched-capacitor converter (SCC) to form a Multi-resonance-core-based (MRC) Dickson Resonant Switched-capacitor Converter (RSC). All charging and discharging loops achieve soft-charging, so the inherent capacitor charge sharing loss and the high current transient spikes are eliminated. The modular configuration makes the MRC Dickson easy to be extended to a higher voltage level. The On-time fixed frequency modulation is adopted, all transistors being turned on with ZCS operation and all diodes being turned off with ZCS operation. Most importantly, the conversion ratio of the MRC Dickson can be regulated continuously, widely and efficiently even at light load condition, which is a huge advantage over the traditional Dickson SCC with limited control headroom. A comprehensive analysis of the operation principle, voltage-gain curve, component stress analysis and output characteristic is provided. The converter operation principle and regulation capability were verified by both simulation and experiment.

28 July 2021 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
SLShouxiang Li
Shouxiang Li
SLShengnan Liang
Shengnan Liang
ZLZhenning Li
Zhenning Li
SZShuhua Zheng
Shuhua Zheng
In this article, a phase-shift-modulated resonant two-switch boosting switched-capacitor converter (RTBSC) and its modulation map are proposed. Compared with the traditional RTBSC, all diodes are replaced by active switches and then phase-shift modulation is applied. The advantages of the modified topology are obtained as follows. First, the voltage gain can be regulated efficiently either below or above the nominal value within wide range (about ±20%) even at light-load condition, making it suitable for applications with voltage fluctuations, such as the battery charging/discharging system, photovoltaic system and battery/PV voltage equalizer. Second, the conduction loss is reduced by replacing all diodes in RTBSC with low turn- on resistance transistors and adopting phase-shift modulation, especially for high-order and high-gain configuration. Third, all switches achieve the zero-voltage-switching (ZVS) turn- on , reducing the switching loss significantly. Fourth, the soft-charging property smooths the current profile. Aside from the topology modification, a comprehensive analysis of operation principle, voltage gain, component stress and ZVS region is given. On the basis, a modulation map with the optimal operation region is proposed. It provides a guideline to operate and design such converters in the target gain range, low component stress and ZVS region, making up for the lack of modulation map and design guideline. A 120W prototype with low-voltage side 43–60 V and high-voltage side 150 V was designed in the optimal operation region to verify the above analyses.

22 June 2021 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
ZLZhenning Li
Zhenning Li
SLShouxiang Li
Shouxiang Li
SLShanwei Liu
Shanwei Liu
NZNingning Zhang
Ningning Zhang
SZShuhua Zheng
Shuhua Zheng
KSKeyue Ma Smedley
Keyue Ma Smedley
The traditional Dickson switched-capacitor converters (SCCs) come with the shortcomings of high transient current spike, hard-switched operation and limited voltage gain range. In this article, through analyzing the sneak circuit paths, half-bridge Dickson resonant SCCs (HB Dickson RSCs) with “indirect” resonant core are operated and designed in the optimal region where the switching frequency is above resonance. The converters feature soft charging operation, eliminating the high current spike. All transistors achieve zero-voltage-switching turn-on and all diodes have zero-current-switching turn-off. In addition, the voltage-gain range of the HB Dickson RSCs can be expanded significantly and the voltage stress on transistors remains low, equal to the input voltage. An extensive analysis of three operation modes, voltage gain variation range, soft-switching constraints, boundary conditions and component stress is presented to reveal the optimal operation region for 3X(i.e. 3 times) and NX(i.e. N times) HB Dickson RSCs. The optimal operation region is obtained to assist converter operation and hardware design for input/output voltage fluctuation applications. A 24V/29~69.6 V 3X HB Dickson RSC prototype rated at 23-100W with a peak efficiency of 97.8% was designed and built under the hardware guideline. The analysis is verified by experimental results.

24 March 2022 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
ZLZhenning Li
Zhenning Li
SLShouxiang Li
Shouxiang Li
SLShengnan Liang
Shengnan Liang
SZShuhua Zheng
Shuhua Zheng
SZSuli Zou
Suli Zou
GZGuoju Zhang
Guoju Zhang
AbstractIn this paper, a modulation map for a family of phase-shift-modulated resonant switched-capacitor converters (RSCs) which reflects the relationship between the control variables and converter characteristics is proposed to guide the converter operation and design in the expected voltage gain range, low component stress region and zero-voltage-switching (ZVS) operation region. A hybrid modulation strategy combing phase-shift and variable frequency is applied to extend the voltage gain range and ZVS region. On the basis, the modulation map with the favorable operation region is obtained to assist the converter operation and design in the expected conversion ratio range, low component stress region and ZVS operation region. Similar analyzing methods and modulation maps can be extended to N-mode RSCs and other phase-shift-modulated RSCs, providing operation and design reference for such converter families. A 43-60 V to 150 V prototype of a triple-mode RSC with power level 225W and peak efficiency 96.2% was designed and tested to verify the converter operation and validity of the proposed modulation map.

13 December 2023 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
ZLZhenning Li
Zhenning Li
SZSuli Zou
Suli Zou
PYPeng Yang
Peng Yang
QLQian Li
Qian Li
GZGuoju Zhang
Guoju Zhang
SLShouxiang Li
Shouxiang Li
This paper proposes a universal modeling method and a reactive power optimization strategy for phase-shift modulated resonant switched-capacitor converters (RSCs). Compared with the previous steady-state modeling method, only the node voltage between the resonant tanks is needed and the analysis process for different operation states is no longer required. Furthermore, the universal model reflects not only the steady-state characteristics but also the frequency characteristics of phase-shift-modulated RSCs, which can be used to analyze the reactive power directly. In order to minimize the reactive power and thus improve the overall efficiency, an optimized modulation strategy by adopting enumerated algorithm is presented with the help of the proposed universal modeling method. An experimental prototype was built to verify the validity of the model and the effectiveness of the optimized phase-shift modulation strategy.