In this study, a new and simple glassy carbon electrode modified with carbon nanohorns (SWCNH/GCE) was used for the determination of Cr(VI) in aqueous matrices via adsorptive cathodic stripping voltammetry (AdCSV). The modified electrode was characterized via field emission scanning electron microscopy and cyclic voltammetry, which revealed a homogeneous distribution of spherical agglomerates of SWCNH on the electrode surface. The modification increased the electrochemically active area from 0.10 cm² ± 0.01 (GCE) to 0.16 cm² ± 0.01 (SWCNH/GCE). The optimized analytical conditions were as follows: a supporting electrolyte (0.15 mol L⁻¹ HCl), an accumulation potential of 0.8 V versus Ag/AgCl, and an accumulation time of 240 s. Validation of the analytical methodology was performed, obtaining a linear range between 20 and 100 µg L⁻¹, a limit of detection of 3.5 µg L⁻¹, and a limit of quantification of 11.6 µg L⁻¹ with good accuracy and precision. The method was applied to the analysis of spiked tap water samples, and the results were compared using a flame atomic absorption spectrophotometer (FAAS) with no significant statistical differences.

Designing a highly sensitive and efficient functionalized electrode for precise drug analysis remains a significant challenge. In this work, an electrochemical sensor based on a glassy carbon electrode (GCE) modified with phenyl diazonium salts (ph) and electrochemically reduced graphene oxide (ERGO), labeled GCE/ph/ERGO, was developed for the detection of paracetamol (PAR) in pharmaceutical matrices using square wave voltammetry (SWV). The modified electrode was characterized by scanning electron microscopy (SEM), electrochemical impedance spectroscopy (EIS), and cyclic voltammetry (CV). Compared to the bare GCE, the GCE/ph/ERGO sensor demonstrated significantly improved conductivity and anodic current peak for PAR over two orders of magnitude higher, indicating a substantial enhancement in electrochemical performance. Under optimized conditions, the developed sensor exhibited a low detection limit of 18.2 nM and a quantification limit of 60.6 nM. Precision studies yielded relative standard deviations (RSDs) below 8%. The sensor demonstrated excellent selectivity in the presence of common pharmaceutical excipients and high accuracy in the analysis of generic pharmaceutical formulations, with results comparable to those obtained by the HPLC technique. These findings confirm the sensor’s reliability, stability, robustness, and suitability for routine analysis of PAR in pharmaceutical samples.

This paper presents an application for a molybdenum disulfide nanomaterial with multiwalled carbon nanotubes (MoS₂@MWCNT/E) in a modified electrode substrate for the detection of uric acid (UA). The modified electrode generates a substantial three-fold increase in the anodic peak current for UA compared to the unmodified MWCNT electrode (MWCNT/E). The MoS₂@MWCNT/E surface was characterized by cyclic voltammetry (CV), scanning electron microscopy (SEM), energy-dispersive spectroscopy (EDS) and electrochemical impedance spectroscopy (EIS). The achieved detection limit stood at 0.04 µmol/L, with a relative standard deviation (RSD) of 2.0% (n = 10). The method’s accuracy, assessed through relative error and percent recovery, was validated using a urine standard solution spiked with known quantities of UA.

Bacteria in natural environments often encounter high concentrations of metal ions, leading to the development of defense mechanisms such as chemical reduction. This process can result in the formation of nanostructures (NS) ranging from 1–100 nm, which have valuable properties for various applications, including as virucidal agents. Currently, metallic NS with virucidal activity are used in disinfectants and surface protection products. However, their production mainly relies on physical and chemical methods, which are often complex, toxic, and energy-intensive. A sustainable alternative is the biosynthesis of nanostructures. Our research focuses on the biosynthesis of gold nanostructures (AuNS) using environmental bacteria and their proteins, with the aim of exploring their potential as agents to destroy the influenza A virus. We screened bacteria under conditions with HAuCl₄, identifying eight microorganisms capable of growing in high gold concentrations. Staphylococcus haemolyticus BNF01 showed the highest resistance and Au(III) reduction, growing up to 0.25 mM in HAuCl₄. Bioinformatic analysis revealed five proteins with potential Au(III)-reductase activity, which were cloned and expressed in Escherichia coli. These proteins reduced gold to form AuNPs, which were purified, characterized for size, shape, and surface charge, and tested against influenza A, showing significant virucidal effects, likely due to interactions with viral proteins.