The agave fructans as carrier agent can be an alternative to increase quality properties of blackberry. The aim of this study was to evaluate the effect of agave fructans concentration and inlet air temperature on quality properties of blackberry powder. Agave fructans concentrations were 50, 75 and 100 % (in base the total soluble solids percentage of blackberry extract), and the inlet air temperatures were 70–110 °C. A pilot-scale spray dryer was employed. Drying yield ranged from 58 to 94 % dry base. Encapsulation efficiency values varied between 48 and 100 % of anthocyanin concentration. The lower agave fructans concentration showed the best quality characteristics as lower water activity of 0.28, high anthocyanin retention of 98 %, high bulk density of 0.80 g/ml and the higher agave fructans concentrations showed the best stability properties as lower hygroscopicity of 0.013 g _H20 /g _solids and low particle temperature of 38 °C. The agave fructans improves good physicochemical and stability characteristics in blackberry powders.

The objective of this investigation was to evaluate the influence of two carrier agents, Nopal and Aloe Vera mucilage on the physicochemical properties and stability of blackberry and raspberry powders obtained by spray drying. A pilot scale spray dryer with a feed flow of 20 L/h and an atomization speed of 28,000 rpm was used. The inlet and outlet air temperatures were from 180 to 80 °C, respectively. Yield, moisture content, water activity, hygroscopicity index, solubility time, volumetric density, stability diagrams, micrographs, and particle temperature were evaluated. The highest yields for blackberry extract were 75% with a concentration of 2.5% (w/v) Nopal mucilage, while raspberry extract yielded 65% with a concentration of 5% (w/v) Nopal mucilage. The increase in the concentration of the carrier agent presented an increase in the values of humidity, water activity, volumetric density, and solubility when Nopal mucilage was used as a carrier agent in both blackberry and raspberry extracts. Furthermore, when Aloe Vera mucilage was used as a carrier agent, these same values decreased with increasing concentration. The storage conditions of the powders obtained should be stored at temperatures below 20°C and water activities below 0.4. In addition, the stability diagrams show the particle conditions that should not be exceeded during spray drying.

Coffee (Coffea arabica) cultivation is vital to the global economic, social and cultural life of farmers. However, senescent and disease-susceptible plantations affect coffee productivity. Therefore, it is crucial to improve biotechnological strategies such as micropropagation to increase the number of plants for replanting. In this study, the dark condition (T1) and different light qualities (T0-white light 400–700 nm; T2-red light 660 nm and T3-blue light 460 nm) were evaluated to optimize the in vitro propagation of 4 and 9 month-old coffee seeds. The results showed that red light had the highest percentage, an outstanding germination rate index, which may suggest that in the case of coffee seeds could be involved phytochromes that promote germination in a red light quality. In summary, the ideal conditions for in vitro micropropagation of coffee are under white and red light condition.

The utilization of microorganisms as biocontrol agents represents a sustainable alternative to agrochemicals. Trichoderma spp. has been identified as a fungus that promotes plant growth and suppresses phytopathogens. Nonetheless, conventional commercial formulations are constrained by factors such as their limited shelf life, environmental sensitivity, and inadequate carrier systems. In this study, Trichoderma harzianum (T22) and T. viride (T18) strains were encapsulated in a hydrogel composed of chitosan, gelatin, and polyvinyl alcohol, which was prepared by pH-induced gelation via alkaline precipitation. The characterization of the hydrogels was conducted in several domains. Initially, the water absorption of the samples was examined at varying pH values. Secondly, the morphology of the samples was investigated using scanning electron microscopy (SEM) and stereo microscopy. Thirdly, the chemical interactions in the hydrogels were analyzed by Fourier-transform infrared spectroscopy (FTIR). The final stage of the experiment involved assessing the degradation behaviour of the hydrogels in both sterile and inoculated soils. The efficacy of the isolates in protecting chilli plants from Phytophthora capsici was subsequently evaluated. As demonstrated in the extant research, encapsulation techniques have been shown to preserve the viability of fungal organisms and promote their growth after 10 days of storage at ambient temperature. These effects have been observed to exhibit strain-dependent variations. It is noteworthy that hydrogels loaded with T. viride (HT18) induced resistance against P. capsici, resulting in complete symptom suppression and enhanced plant growth, whereas hydrogels loaded with T. harzianum (HT22) showed no protective effect. These results demonstrate the potential of the hydrogel formulated with T18 as an effective carrier, as it maintains Trichoderma spp. viability and protects chilli plants against P. capsici infection.

Solar collectors are thermal devices that can trap solar energy and convert it to heat. This heat can be used for different industrial applications, for example, the drying of food is one of the most useful applications of solar collectors. This work aims to design and build a solar collector using nanofluids for the convective drying of food. The dimensions of the solar collector were 1 m2 by 20 cm with an angle of inclination of 45°. The collector was composed of 9-mm thick tempered glass and a heat exchanger in which the nanofluids circulate. Nanofluids were designed based on canola oil and nanopowders (>50 nm) of Al2O3, CuO, and a 1:1 (w/w) mixture of both. Thermal profiles were determined using differential scanning calorimetry (DSC). The solar collector temperatures were recorded using an Agricos® unit. The maximum temperatures of the air leaving the collector were 39.1°C, 44°C, 54°C, and 47.1°C for canola oil, and the nanofluids composed of Al2O3, CuO, and the 1:1 mixture, respectively, with a maximum efficiency of 65.09%. An increase in the outlet air temperature was observed using the nanofluids compared to canola oil alone