The axion has emerged as the most attractive solution to two fundamental questions in modern physics related to the charge-parity invariance in strong interactions and the invisible matter component of our Universe. Over the past decade, there have been many theoretical efforts to constrain the axion mass based on various cosmological assumptions. Interestingly, different approaches from independent groups produce good overlap between 20 and . We performed an experimental search to probe the presence of dark matter axions within this particular mass region. The experiment utilized a multicell cavity haloscope embedded in a 12 T magnetic field to seek for microwave signals induced by the axion-photon coupling. The results ruled out the KSVZ axions as dark matter over a mass range between 21.86 and at a 90% confidence level. This represents a sensitive experimental search guided by specific theoretical predictions.
In the search for axion dark matter, the cavity-based haloscope offers the most sensitive approach to the theoretically interesting models in the microwave region. However, experimental searches have been limited to relatively low masses up to a few tens of , benefiting from large detection volumes and high-quality factors for a given experimental setup. We propose a new cavity design suitable for axion searches in higher mass regions with enhanced performance. The design features a periodic arrangement of dielectric material in a conventional conducting cavity where the resonant frequency is determined by the interspace. This photonic crystal haloscope can make full use of a given volume even at high frequencies while substantially improving the cavity quality factor. An auxetic structure is considered to deploy the array for two-dimensional frequency tuning. We present the characteristics of this haloscope design and demonstrate its feasibility for high-mass axion searches.
4 May 2023 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
Axions are hypothesized particles believed to potentially resolve two major puzzles in modern physics: the strong C P problem and the nature of dark matter. Cavity-based axion haloscopes represent the most sensitive tools for probing their theoretically favored couplings to photons in the microelectronvolt range. However, as the search mass (or frequency) increases, the detection efficiency decreases, largely due to a decrease in cavity volume. Despite the potential of higher-order resonant modes to preserve experimental volume, their practical application in searches has been limited by the challenge of maintaining a high form factor over a reasonably wide search bandwidth. We introduce an innovative tuning method that uses the unique properties of auxetic materials, designed to effectively tune higher modes. This approach was applied to the TM 020 mode for a dark matter axion search exploring a mass range from 21.38 to 21.79 μ eV , resulting in the establishment of new exclusion limits for axion-photon coupling greater than approximately 10 − 13 GeV − 1 . These findings should allow use of higher-order modes for cavity haloscope searches. Published by the American Physical Society 2024
21 April 2023 in Journal of the Korean Physical Society
We describe a new axion search method based on measuring the variance in the interference of the axion signal using injected photons with a power detector. The need for a linear amplifier is eliminated by putting a strong signal into the microwave cavity, to acquire not only the power excess but also measure the variance of the output power. The interference of the external photons with the axion to photon converted signal greatly enhances the variance at the particular axion frequency, providing evidence of its existence. This method has an advantage in that it can always obtain sensitivity near the quantum noise limit even for a power detector with high dark count rate. We describe the basic concept of this method both analytically and numerically, and we show experimental results using a simple demonstration circuit.