Cervical laminoplasty is an established motion-preserving procedure for degenerative cervical myelopathy (DCM). However, patients with pre-existing cervical kyphosis often experience inferior outcomes compared to those with straight or lordotic spines. Limited dorsal spinal cord shift in kyphotic spines post-decompression and increased spinal cord tension may contribute to poor neurological recovery and spinal cord injury. This study aims to quantify the biomechanical impact of cervical sagittal alignment on spinal cord stress and strain post-laminoplasty using a validated 3D finite element model of the C2–T1 spine. Three models were created based on the C2–C7 Cobb angle: lordosis (20 degrees), straight (0 degrees), and kyphosis (−9 degrees). Open-door laminoplasty was simulated at C4, C5, and C6 levels, followed by physiological neck flexion and extension. The results showed that spinal cord stress and strain were highest in kyphotic curvature compared to straight and lordotic curvatures across all cervical segments, despite similar segmental ROM. In flexion, kyphotic spines exhibited 103.3% higher stress and 128.9% higher strain than lordotic spines and 16.7% higher stress and 26.8% higher strain than straight spines. In extension, kyphotic spines showed 135.4% higher stress and 241.7% higher strain than lordotic spines and 21.5% higher stress and 43.2% higher strain than straight spines. The study shows that cervical kyphosis leads to increased spinal cord stress and strain post-laminoplasty, underscoring the need to address sagittal alignment in addition to decompression for optimal patient outcomes.
30 August 2024 in International Journal of Spine Surgery
Background Expandable transforaminal lumbar interbody fusion (TLIF) cages could offer an alternative to anterior lumbar interbody fusion (ALIF). Bilateral cage insertion enhances endplate coverage, potentially improving stability and fusion rates and maximizing segmental lordosis. This study aims to compare the biomechanical properties of bilateral expandable TLIF cages to ALIF cages using finite element modeling. Methods We used a validated 3-dimensional finite element model of the lumbar spine. ALIF and TLIF cages were created based on available product data. Our focus was on analyzing spinal motion in the sagittal plane, evaluating forces transmitted through the vertebrae, and comparing an ALIF model with various TLIF cage models. Results The largest TLIF cage model exhibited a 407.9% increase in flexion motion and a 42.1% decrease in extension motion compared with the ALIF cage. The second largest TLIF cages resulted in more flexion motion and less extension motion compared with ALIF, while smaller cages were inferior to ALIF. ALIF cages were associated with increased adjacent segment motion compared with TLIF cages, primarily in extension. Endplate stress analysis revealed higher stress in the ALIF cage model with a more uniform stress distribution. Conclusion ALIF cages excel in stabilizing L5 to S1 during flexion, while largest TLIF cages offer superior stability in extension. Large bilateral TLIF cages may provide biomechanical stability comparable to ALIF, especially in extension and could potentially reduce the risk of adjacent segment disease with lower adjacent segment motion. Level of Evidence 5.
Degenerative cervical myelopathy (DCM) is characterized by progressive neurological dysfunction, yet the contribution of intramedullary stress and strain during neck motion remains unclear. This study used patient-specific finite element models (FEMs) of the cervical spine and spinal cord to examine the relationship between spinal cord biomechanics and neurological dysfunction. Twenty DCM patients (mean age 62.7 ± 11.6 years; thirteen females) underwent pre-surgical MRI-based modeling to quantify von Mises stress and maximum principal strains at the level of maximum spinal cord compression during simulated neck flexion and extension. Pre-surgical functional assessments included hand sensation, dexterity, and balance. During flexion, the mean intramedullary stress and strain at the level of maximum compression were 7.6 ± 3.7 kPa and 4.3 ± 2.0%, respectively. Increased intramedullary strain during flexion correlated with decreased right-hand sensation (r = −0.58, p = 0.014), impaired right-hand dexterity (r = −0.50, p = 0.048), and prolonged dexterity time (r = 0.52, p = 0.039). Similar correlations were observed with intramedullary stress. Patients with severe DCM exhibited significantly greater stress during flexion than those with mild/moderate disease (p = 0.03). These findings underscore the impact of dynamic spinal cord biomechanics on neurological dysfunction and support their potential utility in improving DCM diagnosis and management.
21 November 2024 in Journal of Engineering and Science in Medical Diagnostics and Therapy
To determine behind armor blunt trauma (BABT) injury criteria, experiments have been conducted by launching blunt projectiles at live swine at velocities up to 65 meters per second (m/s) using one type of indenter design. To ensure the generalizability of the developed injury criteria, additional tests with different indenter designs are needed. The objectives of this study were to evaluate the kinematics and injury parameters from two indenter designs using human body finite element modeling. The simulation matrix consisted of chord and cylindrical shape indenter designs with two different masses of 150 and 230 grams. They were used to impact the liver and lung regions at velocities of 30 and 60 m/s using a human body model. Rib and lung strains from lung impacts and rib strain and liver strain energy densities (SED) from liver impacts were used to evaluate the design variables of mass and shape. Both designs played a role in skeletal and organ injury parameters. Analysis revealed an increased susceptibility for skeletal and organ traumas with the high mass indenter during high velocity impacts. The cylindrical indenter may be protective for organ injuries due to the larger area of loading on the ribcage compared to the chord indenter. Results from the chord indenter may serve as a conservative estimate of injury criteria.