Electronic controlled drug release from fibres was studied using ibuprofen as a model drug, one of the most popular analgesics, to impregnate gauze and cellulose acetate (CA) membranes. Conductivity in the range of 1–10 mS cm−1 was obtained in polypyrrole (Ppy) functionalised gauze and CA fibres, providing voltage-controlled drug release in a system consisting of Ppy/Ibuprofen/Ppy membranes and an Ag electrode. SEM images evidenced the Ppy adhesion to fibres and Micro Raman spectra proved drug incorporation and release. A small wound adhesive built with these membranes retains ibuprofen at 1.5 V and quickly releases it when −0.5 V is applied.
This study explores a method that has the potential to be cost effective in inhibiting biofilm formation on metallic prostheses, thereby preventing rejection or the requirement for replacement. A cost-effective metal alloy used in biomedical implants was chosen as the substrate, and ibuprofen (Ibu), a well-known anti-inflammatory drug, was selected for drug release tests for its widespread availability and accessibility. Multilayer coatings consisting of cellulose acetate (CA), polycaprolactone (PCL), and chitosan (CHI), with or without ibuprofen (Ibu) content, were applied onto medical-grade stainless steel (SS-316 type) through electrospinning, electrospray, or blow spinning. The adhesion of the CA, PCL, and layered CA/PCL membranes, with thicknesses ranging from 20 to 100 μm, to SS substrates varied between 0.15 N and 0.22 N without CHI, which increased to 0.21 and 0.74 N, respectively, when a CHI interlayer was introduced by electrospraying between the SS and the coatings. Although drug release in a simulated body fluid (SBF) medium is predominantly governed by diffusion-driven mechanisms in all single- and multilayer coatings, a delayed release was noted in CA coatings containing Ibu when overlaid with a PCL coating produced by blow spinning. This suggests avenues for further investigations into combinations of multilayer coatings, both with and without drug-imbued layers.
Controlled drug release via electrical stimulation from drug-impregnated fibres was studied using electrospun cellulose acetate (CA) membranes and encapsulated ibuprofen (IBU). This research outlines the influence of polypyrrole (PPy) and poly(3,4-ethylenedioxythiophene) (PEDOT)-functionalised CA membranes and their suitability for dermal electronic-controlled drug release. Micro Raman analysis confirmed polymer functionalisation of CA membranes and drug incorporation. Scanning electron microscopy (SEM) images evidenced the presence of PPy and PEDOT coatings. The kinetic of drug release was analysed, and the passive and active release was compared. In the proposed systems, the drug release is controlled by very low electrical potentials. A potential of −0.3 V applied to membranes showed the ibuprofen retention, and a positive potential of +0.3 V, +0.5 V, or +0.8 V, depending on the conductive polymer and membrane configuration, enhanced the drug release. A small adhesive patch was constructed to validate this system for cutaneous application and verified an “ON/OFF” ibuprofen release pattern from membranes.