Knowing and promoting the strength development of concrete at an earlier age is essential for accelerating formwork circulation of the on-site construction and precast product manufacture. The strength development rate at earlier ages of less than the initial 24 h was investigated. The effect of measures of adding silica fume, calcium sulfoaluminate cement, and early strength agent on the strength development of earlier concrete at ambient temperatures of 10, 15, 20, 25, and 30 °C was studied. The microstructure and long-term properties were further tested. It is shown that the strength increases exponentially first and then logarithmically, different from what is commonly recognized. Increasing cement content exhibited a certain effect only above 25 °C. When the cement content increased from 420 to 460 kg/m3, the strength only increased from 6.2 to 6.7 MPa after 12 h at 25 °C. The early strength agent could increase the strength significantly, the strength could be increased from 6.4 to 10.8 MPa after 20 h at 10 °C and from 7.2 to 20.6 MPa after 14 h at 20 °C. All measures for promoting earlier strength did not have an evident negative effect. The results could be potentially referred for the formwork removal at a suitable moment.
Magnesium phosphate cement (MPC), a cementitious material that hardens through an acid–base reaction, is theoretically expected to exhibit strong acid resistance. However, studies on the durability of MPC in acidic environments remain limited. This study aims to systematically evaluate the acid resistance of MPC in common inorganic acid solutions across various pH levels. By measuring changes in compressive strength, mass loss, apparent changes, pH changes, and the microstructure evolution of MPC under acidic conditions, the mechanisms and influencing factors of its acid resistance are revealed. The results indicate that at pH levels of 1.0 and 2.0, MPC’s resistance to H2SO4 and HCl erosion is markedly superior compared to its performance against H3PO4, as evidenced by compressive strength retention, mass loss, and visible erosion. At pH levels above 2.0, MPC demonstrates robust resistance to all tested corrosive media, with compressive strength retention ranging from 68.9% to 86.9%, irrespective of the acid source. Although new corrosion products form in these acidic environments, the adverse effects of NH4/P loss from struvite, along with the redissolution of corrosion products due to their higher solubility, increase porosity and subsequently reduce the mechanical strength. Nevertheless, considering that strength retention is significantly higher than that of other cement-based materials reported in the literature, MPC still exhibits good acid resistance and is suitable for environments requiring enhanced resistance to acid corrosion.
13 September 2025 in Journal of Building Engineering