In Wire Arc Additive Manufacturing (WAAM), variable layer heights enable the non-parallel or non-planar slicing of parts. In researching variable layer heights, this paper documents printing strategies for a reference geometry whose key features are non-orthogonal growth and unsupported overhangs. The complexity of 3D printing with welding requires parameter optimization to control the deposition of molten material. Thus, 3D printing with welding requires the precise deposition of molten material. Currently, there is no standard solution for the customization of process parameters and intelligent collection of data from sensors. To address this gap in technology, this research develops an Internet of Things (IoT)-enabled, distributed communication protocol to control process parameters, synchronize commands, and integrate device data. To intelligently collect sensor information, this research creates a query-able database during pre-planning and production. This contributes to fundamental research in WAAM by documenting strategies for printing variable layer heights, the customization of control parameters, and the collection of data through a WAAM Information Model (WIM).
Wire arc additive manufacturing (WAAM) integrates benefits of automation and mass customization to improve efficiency through near-net part production. While WAAM is well researched, there remain significant challenges as the complex relationship between robot, welder, and process parameters can lead to inaccuracy in geometry and variations in material properties. This research proposes a novel framework for quantifying the WAAM process and proposes dynamic adaptive strategies for improving production. This paper introduces the concept of an equivalent contact surface (ECS) for quantifying the additive welding process. Adaptive methods are then identified to optimize WAAM production. In conclusion, this paper provides an outlook on future research directions for continuing the development of this dynamic WAAM process.
24 March 2026 in Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
A wide selection of electronically controlled process variants (PV) is available for gas metal arc welding. Wire arc additive manufacturing (WAAM) typically uses controlled short arc variants because they provide low heat input and stable deposition characteristics. The control methods, such as specific current waveform or wire retraction, vary between manufacturers. The geometry and material properties of WAAM-parts are contingent on the welding process and, consequently, the underlying algorithms of controlled short arc variant. Currently the knowledge regarding the advantages and disadvantages of controlled short arc variants is limited to specific applications. The aim of this research is to provide a more fundamental approach for the selection of PV for WAAM applications. Six walls out of mild steel, each approximately 5 mm wide, are additively manufactured using three different torch angles and two different PV. By utilizing current and voltage measurements in conjunction with high-speed imaging, the characteristics of the controlled short arc variants are investigated. For PV1, the lowest thickness variation is 0.22 mm at a torch angle of 0°. For PV2, the lowest thickness variation is 0.28 mm at a forward torch angle of 10°. The range between shortest and longest arc times, which is dominated by outliers, is smallest for PV1 at 0° with 1.92 ms and for PV2 at 10° with 2.34 ms. Surface errors such as uneven layer height and instances of material overflow correlate with the delta. This finding is corroborated by observations of melt pool behavior from high-speed recordings.