We have derived a microscopic, structural model for the GaAs(001)-(6×6) surface reconstruction using scanning tunneling microscopy. It involves three atomic layers containing both As and Ga dimers. Previous studies suggested the (6×6) structure to be poorly ordered, often it was only described as a (1×6) superstructure. In contrast, we find a well-developed (6×6) superstructure with As-dimer rows in the [11¯0] direction separated by 24 Å. However, this reconstruction may not be a stable equilibrium structure.
27 May 2011 in IEEE Journal of Quantum Electronics
This paper examines and models the effect of temperature on the mode-locking capability of monolithic two-section InAs/GaAs quantum dot passively mode-locked lasers. A set of equations based on an analytic net-gain modulation phasor approach is used to model the observed mode-locking stability of these devices over temperature. The equations used rely solely on static material parameters, measured on the actual device itself, namely, the modal gain and loss characteristics, and govern the limit describing the onset of mode-locking. Employment of the measured gain and loss characteristics of the gain material over temperature, wavelength and current injection in the model provides a physical insight as to why the mode-locking shuts down at elevated temperatures. Moreover, the model enables a temperature-dependent prediction of the range of cavity geometries (absorber to gain length ratios) where mode-locking can be maintained. Excellent agreement between the measured and the modeled mode-locking stability over a wide temperature range is achieved for an 8-stack InAs/GaAs quantum dot mode-locked laser. This is an attractive tool to guide the design of monolithic passively mode-locked lasers for applications requiring broad temperature operation.
GaN nanocolumns were synthesized on single-layer graphene via radio-frequency plasma-assisted molecular beam epitaxy, using a thin migration-enhanced epitaxy (MEE) AlN buffer layer as nucleation sites. Due to the weak nucleation on graphene, instead of an AlN thin-film we observe two distinguished AlN formations which affect the subsequent GaN nanocolumn growth: (i) AlN islands and (ii) AlN nanostructures grown along line defects (grain boundaries or wrinkles) of graphene. Structure (i) leads to the formation of vertical GaN nanocolumns regardless of the number of AlN MEE cycles, whereas (ii) can result in random orientation of the nanocolumns depending on the AlN morphology. Additionally, there is a limited amount of direct GaN nucleation on graphene, which induces non-vertical GaN nanocolumn growth. The GaN nanocolumn samples were characterized by means of scanning electron microscopy, transmission electron microscopy, high-resolution X-ray diffraction, room temperature micro-photoluminescence, and micro-Raman measurements. Surprisingly, the graphene with AlN buffer layer formed using less MEE cycles, thus resulting in lower AlN coverage, has a lower level of nitrogen plasma damage. The AlN buffer layer with lowest AlN coverage also provides the best result with respect to high-quality and vertically-aligned GaN nanocolumns.
Flip-chip ultraviolet light-emitting diodes based on self-assembled GaN/AlGaN nanocolumns have been fabricated, exploiting single-layer graphene not only as a growth substrate but also as a transparent conducting electrode. High crystalline quality of the nanocolumns is confirmed by detailed electron microscopy characterization, also showing the intrinsic GaN quantum disk in the active region of the nanocolumns. These features are further confirmed in the optical emission, where the absence of defect-related yellow emission and the presence of blue-shifted (from the usual 365 nm band gap emission of bulk wurtzite GaN) emission at ∼350 nm, ascribed to quantum confinement and strain effects, are observed. Despite a noticeable graphene damage after the nanocolumn growth that causes high sheet resistance of graphene and high turn-on voltage, the proof of concept of single-layer graphene used as the transparent conducting substrate for a nanocolumn device is demonstrated. This study offers an alternative platform for the fabrication of next-generation nano-optoelectronic and electronic devices.