Direct numerical simulations of a turbulent channel flow with a passive scalar at with blowing perturbations is carried out. The blowing is imposed through five spanwise jets located near the upstream end of the channel. Behind the blowing jets (about , where D is the jet diameter), we observe regions of reversed flow responsible for the high temperature region at the wall: hot spots that contribute to further heating of the wall. In between the jets, low pressure regions accelerate the flow, creating long, thin, streaky structures. These structures contribute to the high temperature region near the wall. At the far downstream of the jet (about ), flow instabilities (high shear) created by the blowing generate coherent vortical structures. These structures move hot fluid near the wall to the outer region of the channel; thereby, these are responsible for cooling of the wall. Thus, for engineering applications where cooling of the wall is necessary, it is critical to promote the generation of coherent structures near the wall.
The effects of upstream perturbations on large-scale field are analyzed using direct numerical simulation data of a channel flow of frictional Reynolds number, , 394. A set of three and five spanwise blowing jets are used to create the upstream perturbations. The premultiplied energy spectra show that upstream perturbations led to the increase in range of large-scale wavenumbers in contrast to the unperturbed channel flow. The energy of wavenumbers lower than inertial sub-range ( power law) shows an increase in energy due to the perturbations and sustained downstream up to x =10D from jets. Two-point correlation based Gaussian filter is used to extract large-scale features of correlation length greater than 2h (where h is channel half-height). Premultiplied energy spectra of the Gaussian filtered large-scales demonstrate the importance of jet spacing and diameter in exciting large-scale wavenumbers. The λ2 vortices of large-scale features formed a strong ring-type vortices at . Spectral turbulence kinetic energy (TKE) production depicts a secondary peak in TKE production at , which indicates the formation of a shear layer due to the upstream perturbations.
Adverse-pressure-gradient turbulent boundary layer flow was inspected at Reynolds number based on momentum thickness, , using particle image velocimetry in a refractive-index-matching flume. Proper orthogonal decomposition was used to quantify the effect of large-scale motions on the Reynolds stresses at the onset of separation and within the separated flow. Results show that approximately of the Reynolds shear stress, , is due to large-scale motions containing of the turbulence kinetic energy at the tested Reynolds number. The decomposed velocity field revealed that only the first of the modes is sufficient to recover of the turbulence kinetic energy. In this partition, the large-scale motion contribution to the streamwise component of the Reynolds normal stress, , is about and continues to grow with flow separation. In addition, the large- and small-scale motions equally contributed to the vertical component of the Reynolds normal stress, , and the contribution of the large-scale motions increased as the flow separated. Overall, results emphasise the significant impact of the large-scale motions on the Reynolds stresses in the separated flow, which may impact flow control strategies.