Compared with traditional propellers, the pump jet has the characteristics of low noise, large thrust, and high efficiency, which is widely used in underwater ships, unmanned underwater vehicles, and underwater rescue equipment. It is difficult to design and evaluate the performance of a pump jet because of its complex structure and the many changes in its component parameters. In this paper, high-efficiency pump jet design and optimization methods are presented. Based on the center-of-gravity accumulation line control, a design method is proposed to design the pump jet rotor. The thrust performance and hydraulic performance of the pump jet are obtained through numerical simulation, and the influence of various parameters on performance is studied. Finally, based on a single-factor analysis and orthogonal optimization, a multi-parameter orthogonal optimization of pump jet was carried out. The angle of attack, chord length, camber angle, and number of blades were selected to establish a four-factor and three-level orthogonal table. The thrust efficiency was taken as the optimization goal. Compared to the original pump jet, the optimized pump jet thrust coefficient and thrust efficiency are significantly improved at various speed conditions, with the maximum thrust efficiency increased by 7.23%, meeting the design requirements. This research provides a theoretical basis and technical guidance for the structural optimization design of a pump jet propulsion system.

In order to investigate the laws of the laser peening forming process and the effects of laser peening on the surface quality and tensile properties of 5083 aluminum alloy, experiments were conducted utilizing various laser peening paths, energies, and plate thicknesses. Subsequently, laser peening forming experiments were performed on S-shaped and different shapes of aluminum alloy substrates. The impact of different laser peening durations on surface morphology and tensile properties was then analyzed. Results indicated that the largest bending deformation perpendicular to the laser peening path reached 12.5 mm. In cases where the laser peening path was inclined relative to the horizontal direction, torsional deformations were observed in the aluminum alloy plate. For laser energy levels of 5 J, 6 J, and 7 J, deformation amounts were 3.8 mm, 4.9 mm, and 5.4 mm, respectively. Plates with thicknesses of 4 mm exhibited convex deformation, while those with 2 mm thickness showed concave deformation. Furthermore, following one and two laser peening cycles, the residual stresses in the alloy plates were −80 MPa and −107 MPa, the surface hardness increased by 16 HV and 31 HV, the roughness increased by 2.495 μm and 3.615 μm, and the tensile strength increased by 9.5 MPa and 18.5 MPa, respectively.

The horizontal-axis tidal turbine is a representative device for harnessing ocean tidal energy, and the structural optimization of its blades is crucial for enhancing the power capture efficiency. In this work, the twist and chord distributions of the blade are determined using an improved Blade Element Momentum (BEM) approach, in which tip and hub loss factors are employed to enhance the modeling accuracy, and these results are employed to construct a parametric model of the original rotor. Due to its simplified assumptions and inability to capture three-dimensional flow effects, computational fluid dynamics (CFD) simulations were carried out to evaluate the hydrodynamic performance and flow analysis of the designed rotor. Further, the orthogonal test method was used to optimize the hydraulic performance of the rotor. Three optimization parameters, namely hub diameter, airfoil type, and maximum airfoil thickness, were set with three levels. Based on the orthogonal design scheme, nine rotor configurations were generated, and their energy capture characteristics and flow fields were subsequently evaluated through numerical simulations. The analysis indicates that the choice of airfoil exerts the strongest impact on the rotor’s energy capture efficiency, while the influences of maximum airfoil thickness and hub diameter follow in descending order. Consequently, the optimized rotor adopts a NACA63-415 airfoil with a reduced maximum thickness of 0.9 T₀ and an intermediate hub diameter of 15%R, achieving a power coefficient of 0.445 at the design tip-speed ratio of 4, corresponding to a 3.08% improvement compared with the original design. Flow field analysis demonstrates that the optimized geometry promotes a more uniform spanwise pressure distribution and effectively suppresses flow separation, thereby enhancing the overall hydrodynamic efficiency.