Comparing polymer matrix composites with conventional composites, such as continuous fiber-reinforced composites, shows a considerable increase in strength and fracture toughness. In this study, compression molding was used to create hybrid (carbon and silk fabric-reinforced) and carbon fabric-reinforced epoxy matrix composites using a hand layup process. This article discusses the evaluated flexural strength (FS) and plane strain Mode-I fracture toughness of composite materials. The impact of carbon fabric reinforcement on the fracture toughness of these composites was assessed using the obtained results. It was found that the addition of silk fabric reinforcement decreased the hybrid composite’s plane strain Mode-I fracture toughness. Fracture toughness and FS are higher in carbon fabric-reinforced composite than in hybrid composite.
1 February 2021 in IOP Conference Series: Materials Science and Engineering
Wear component is an important factor influencing products service life which is based on material property and their behavior under given conditions. Therefore it is important to predict wear rate of components. In this paper we have discussed the wear parameters of pin on disc by varying pin materials. Numerical analysis was conducted on basis of load for different material components. When two bodies are in contact, contact pressure induces stresses in components.. Due to coefficient of friction, heat is generated between components. Hertz theory has been considered to determine the wear characteristic by using different pin materials on a steel disc. It was observed that aluminium alloy pin on steel disc generated low coefficient of friction, temperature rise and wear rate.
Low-resource speech recognition remains fundamentally limited by training distribution, as neural networks cannot access linguistic knowledge beyond their training data. SAREC (Semantic-Aware Retrieval Enhanced Conformer), a novel neural architecture that augments Conformer-based acoustic encoders with dynamically retrieved phonetic exemplars during both training and inference. The key innovation is frame-level retrieval with learned cross-attention fusion, enabling phonetic-precision knowledge integration at each encoding layer. Unlike existing utterance-level retrieval approaches (SRAG), SAREC system retrieves and fuses acoustic prototypes at frame granularity, capturing phonetic patterns at multiple scales through strategic insertion at encoder layers 3, 6, 9, and 12. A learned gating mechanism dynamically weights acoustic versus exemplar information per frame, providing principled information fusion superior to simple concatenation. Evaluation on Telugu, Kannada, Tamil demonstrates consistent improvements: Telugu 18.2% WER (Word Error Rate) ( (vs. 21.4% baseline, 15.0% relative, p < 0.001, 95% CI: [17.8, 18.6]%); Kannada 20.3% (vs. 24.8%, 18.1% relative); Tamil 16.4% (vs. 19.2%, 14.6% relative). Robustness improves 12.1% at 5 dB SNR (Signal to Noise Ratio), latency remains practical (356 ms/10s audio). Ablation studies confirm frame-level superiority (15% over utterance-level, K = 5 optimal).Three mechanisms explain gains: (1) phonological disambiguation, (2) morphological integration, (3) cross-dialect generalization. Results advance low-resource ASR accessibility through systematic frame-level retrieval augmentation
1 August 2017 in IOP Conference Series: Materials Science and Engineering
Multi lobe journal bearings are used in machines which operate at high speeds and high loads. In this paper the multi lobe bearing are analyzed to determine the effect of surface roughness during non linear loading. A non-linear time transient analysis is performed using the fourth order Runge Kutta method. The finite difference method is used to predict the pressure distribution over the bearing surface. The effect of eccentric ratio is studied and the variation of attitude angle is discussed. The journal center trajectories were calculated and plotted.